Materials in the Drive Chain – Modeling Materials for the Internet of Production
Authors:
- Ali RajaeiARAli Rajaei
- Marco BeckerMBMarco Becker
- Yuanbin DengYDYuanbin Deng
- Oliver SchenkOSOliver Schenk
- Soheil RooeinSRSoheil Rooein
- Patricia de Oliveira LöhrerPLPatricia de Oliveira Löhrer
- Niklas ReinischNRNiklas Reinisch
- Tarik ViehmannTVTarik Viehmann
- Mustapha AbouridouaneMAMustapha Abouridouane
- Mauricio FernándezMFMauricio Fernández
- Christoph BroeckmannCBChristoph Broeckmann
- Thomas BergsTBThomas Bergs
Open Access
- 30 December 2023
- book chapter
- Published by Springer Nature
- p. 187-207
Abstract
In this chapter, the focus lies on a predictive description of the material response to the thermomechanical loads within different process steps by means of physical and data-driven models. The modeling approaches are demonstrated in examples of innovative production technologies for components of a drive chain: Fine blanking of parts; powder metallurgical (PM) production of gears; open-die forging and machining of drive shafts. In fine blanking, material, process, and quality data are acquired to model interactions between process and material with data-driven methods. Interpretable machine learning is utilized to non-destructively characterize the initial material state, enabling an optimization of process parameters for a given material state in the long-term. The PM process chain of the gear includes sintering, pressing, surface densification, case hardening, and finishing by grinding. Several modeling and characterization approaches are applied to quantitatively describe the microstructure evolutions in terms of porosity during sintering, density profile after cold rolling, hardness and residual stresses after heat treating and grinding and the tooth root load bearing capacity. In the example of the open-die forging, a knowledge-based approach is developed to support the decision-making process regarding the choice of the proper material and optimized pass schedules. Considering the microstructure of the forged shaft, the elastoplastic material behavior is described by a dislocation-based, multiscale modeling approach. On this basis, process simulations could be carried out to predict the process forces, chip form, residual stresses, and the tool life among other output data.Keywords
This publication has 33 references indexed in Scilit:
- Relation Between Magnetic Barkhausen Noise and Hardness for Jominy Quench Tests in SAE 4140 and 6150 SteelsJournal of Nondestructive Evaluation, 2012
- Analysis of the drive shaft fracture of the bucket wheel excavatorEngineering Failure Analysis, 2012
- Finite Element Simulation of Mass Transport During Sintering of a Granular Packing. Part I. Surface and Lattice DiffusionsJournal of the American Ceramic Society, 2012
- Energy consumption in powder metallurgical manufacturingPowder Metallurgy, 2012
- A Microstructural and Fractographic Study on the Failure of a Drive ShaftJournal of Failure Analysis and Prevention, 2011
- Introduction to discrete element methodsEuropean Journal of Environmental and Civil Engineering, 2008
- Thermal Analysis of GrindingCIRP Annals, 2007
- On the Mechanics of the Grinding Process Under Plunge Cut ConditionsJournal of Engineering for Industry, 1966
- A general equation prescribing the extent of the austenite-martensite transformation in pure iron-carbon alloys and plain carbon steelsActa Metallurgica, 1959
- Granulation, Phase Change, and Microstructure Kinetics of Phase Change. IIIThe Journal of Chemical Physics, 1941