In situ cure monitoring of adhesively bonded joints by dielectrometry
Authors:
- Jae Wook KwonJKJae Wook Kwon
- Woo Seok ChinWCWoo Seok Chin
- Dai Gil LeeDLDai Gil Lee
- 1 January 2003
- journal article
- Published by Taylor & Francis in Journal of Adhesion Science and Technology
- Vol. 17 (16) , 2111-2130
Abstract
Since the reliability of adhesively bonded joints is much dependent on the curing status of thermosetting adhesives, the in situ cure monitoring during the cure of adhesive joints could improve the quality of adhesively bonded joints as it enables one to control the cure parameters. In this work, a dielectric method which measures the dissipation factor of the adhesive during the cure of joints and converts it into the degree of cure of the adhesive was devised. Steel adherends were used for the adhesively bonded joints because the steel adherends worked as the electrodes for the measurement of dissipation factor without additional electrodes. The relation between the dissipation factor and the degree of cure of adhesive was investigated, which could eliminate the temperature effect on the dissipation factor that is largely affected by the degree of cure and temperature of adhesive. Comparing the results obtained by the method developed with those by DSC (differential scanning calorimetry), it was found that the dissipation factor showed a trend similar to the cure rate of the adhesive.Keywords
This publication has 10 references indexed in Scilit:
- Measurement of the degree of cure of glass fiber–epoxy composites using dielectrometryJournal of Materials Processing Technology, 2001
- The effects of surface roughness and bond thickness on the fatigue life of adhesively bonded tubular single lap jointsJournal of Adhesion Science and Technology, 2000
- In‐process control of epoxy composite by microdielectrometric analysis. Part II: On‐line real‐time dielectric measurements during a compression molding processPolymer Engineering & Science, 1998
- Measurement of the Degree of Cure of Carbon Fiber Epoxy Composite MaterialsJournal of Composite Materials, 1996
- Analysis of dielectric sensors for the cure monitoring of resin matrix composite materialsSensors and Actuators B: Chemical, 1996
- Modeling the dielectric behavior of epoxy resin blends during curingPolymer Engineering & Science, 1994
- On-line cure monitoring and viscosity measurement of carbon fiber epoxy composite materialsJournal of Materials Processing Technology, 1993
- Dynamic Dielectric Analysis for Nondestructive Cure Monitoring and Process Control1987
- Time–temperature–transformation (TTT) cure diagram: Modeling the cure behavior of thermosetsJournal of Applied Polymer Science, 1983
- Relationship between viscoelastic properties and gelation in thermosetting systemsJournal of Applied Polymer Science, 1982