Extreme contact shrink for back end of line connectivity
- 1 May 2022
- journal article
- research article
- Published by American Vacuum Society in Journal of Vacuum Science & Technology B
- Vol. 40 (3) , 032803
Abstract
For the past 50 years, Moore’s law has been well followed by the semiconductor industry. The scaling of transistors and interconnects has been enabled not only by various technological advancements but also by novel patterning approaches. However, in order to keep up with Moore’s law, further shrinking at all levels of the integrated circuit is needed. Among them is the back end of line (BEOL), where increasingly smaller metal pitches require tight specifications for vias connecting metal lines. In this paper, BEOL via shrink options is investigated, targeting the bottom critical dimension (CD) 10.5 nm in order to land on metal pitch 21 nm lines below, while maintaining low defectivity, as well as low global and local CD uniformity (CDU and LCDU, respectively). Approaches to this shrink consist of modifications to the etch chemistry at different levels of the mask etch and liner-assisted shrink, either organic or inorganic. Numerical analysis of CD-scanning electron microscopy (CDSEM) images quantitatively shows the efficiency of different approaches via shrink, together with associated CDU, LCDU, and defectivity values. CDSEM results are supplemented by large-area voltage contrast defectivity and transmission electron microscopy data sets.Keywords
Funding Information
- Chips Joint Undertaking (826422)
This publication has 10 references indexed in Scilit:
- Contact local CD uniformity optimization through etch shrink2021
- Supervia Process Integration and Reliability Compared to Stacked Vias Using Barrierless Ruthenium2020
- Variability-Aware Predictive Modeling of Line-to-Line Dielectric ReliabilityIEEE Transactions on Electron Devices, 2020
- Three-Layer BEOL Process Integration with Supervia and Self-Aligned-Block Options for the 3 nm Node2019
- Ultrathin initiated chemical vapor deposition polymer interfacial energy control for directed self-assembly hole-shrink applicationsJournal of Vacuum Science & Technology B, 2019
- Another step toward the end of Moore's law: Samsung and TSMC move to 5-nanometer manufacturing - [News]IEEE Spectrum, 2019
- Contact hole shrink of 193nm NTD immersion resist2019
- Studying the effects of chemistry and geometry on DSA hole-shrink process in three-dimensionsJournal of Micro/Nanolithography, MEMS, and MOEMS, 2018
- Optimize of shrink process with X-Y CD bias on hole pattern2017
- EUV resist curing technique for LWR reduction and etch selectivity enhancement2012