Slow Current Discharges and Quenching of the MSU Superconducting Cyclotron Gas-Stopper Magnet
Authors:
Open Access
- 11 January 2017
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 27 (4) , 1-5
Abstract
The Michigan State University cyclotron gas-stopper magnet generates a strong focusing cyclotron magnetic field that permits an ion beam of up to 100 MeV/u to enter the magnet and have most of its energy reduced by low-pressure helium gas. The magnet has two superconducting coil cryostats mounted within warm iron poles and a warm split iron return yoke. The coils are connected in series using room temperature cables. The peak magnet stored energy is 3.5 MJ. The magnet has been tested to its full operating current of 180 A. During tests, the magnet discharged inadvertently three times. Two low-current discharges caused the magnet current to decay through the power supply system. A discharge at 180 A quenched the magnet, because the quench protection system caused the magnet to discharge across a 1.25-Ω resistor. This fired the cold quench protection diodes within the cryostat, quenching both coils. The magnetic field in the gap was measured as the magnet discharged. For the two low-current discharges, the magnetic field followed the current in the external magnet circuit. During a quench, the magnetic field decay rate was much slower than the external circuit current decay rate.Keywords
Funding Information
- National Science Foundation
- Michigan State University (PHY-0958726)
This publication has 11 references indexed in Scilit:
- Cold Mass Support System for the MSU Superconducting Cyclotron Gas-Stopper MagnetIEEE Transactions on Applied Superconductivity, 2016
- Simulation of the Quenching of the Cyclotron Gas Stopper Magnet at MSUIEEE Transactions on Applied Superconductivity, 2014
- Voltage Characteristics of Diodes Used for Passive Quench Protection of Low-Current MagnetsIEEE Transactions on Applied Superconductivity, 2014
- Design limitations on a thermal siphon 4 K helium loop for cooling-down the cyclotron gas stopper magnet coilsAIP Conference Proceedings, 2014
- A Comparison of the Quench Analysis on an Impregnated Solenoid Magnet Wound on an Aluminum Mandrel Using Three Computer CodesIEEE Transactions on Applied Superconductivity, 2013
- The Superferric Cyclotron Gas Stopper Magnet Design and FabricationIEEE Transactions on Applied Superconductivity, 2013
- Protecting the Leads of a Powered Magnet That is Protected With Diodes and ResistorsIEEE Transactions on Applied Superconductivity, 2011
- The Role of Quench-Back in the Passive Quench Protection of Uncoupled Solenoids in Series With and Without Coil Sub-DivisionIEEE Transactions on Applied Superconductivity, 2010
- The role of quench back in quench protection of a superconducting solenoidCryogenics, 1984
- Some eddy current effects in solid core magnetsNuclear Instruments and Methods, 1973