The Impact of Thermal Energy Storage on the Emission of Particulate Pollutants into the Atmosphere
Open Access
- 13 December 2024
- journal article
- research article
- Published by MDPI AG in Sustainability
- Vol. 16 (24) , 10926
Abstract
To improve the energy, operational, and ecological efficiency of a district heating system (DHS) powered by a combined heat and power (CHP) plant or a heating plant, thermal energy storage (TES) should be used. The presented paper examines the impact of the use and operation of TES built in a CHP plant supplying a large DHS, based on the amount of particulates emitted into the atmosphere. Detailed research was carried out for the Siekierki–Warsaw and Białystok CHP plants in Poland. The analysis helped to determine the factors affecting the reduction in pollutant emissions and the volume of the energy effect of using TES in the CHP plant. In order to objectify the results of the comparative analysis of the impact of TES in the CHP plant on the emission of particulates, the so-called comparative index (CI) was introduced. The CI takes into account the volume of electricity and heat production and climatic conditions in the analyzed time periods. The CI for the analyzed years should have a similar value so that the results of the comparative analysis are fully representative. This condition is met for the CHP plant and DHS of Białystok, so the detailed results of the analysis are presented for this facility. As a result of the application of TES in the Białystok CHP plant, significant environmental effects related to the reduction in particulate emissions have been achieved; for example, the total amount of annual particulate matter (PM) emission (PM10 and PM2.5) has been reduced by 27% and the maximum emission by 29%. On the other hand, the average decrease in particulate emissions in the heating season varied in the range of 10–50%, while in the summer season, the values of particulate emissions were at a comparable level. A significant decrease in annual and one-hour average concentrations for PM10 and PM2.5 and particulate fallout for these two analyzed years was also found. The use of TES to reduce the occurrence and nuisance of the smog phenomenon, the main components of which are PM, is proposed, and selected models of forecasting concentrations of pollutants in the air, including particulate emissions, are presented in order to implement this type of activity.Keywords
All Related Versions
Funding Information
- Warsaw University of Technology
This publication has 29 references indexed in Scilit:
- Recent Progress on Thermal Energy Storage for Coal-Fired Power PlantJournal of Thermal Science, 2024
- Urban ambient PM10 analysis: Characterization, sources, health risk and sustainable solutionsEnvironmental Chemistry and Ecotoxicology, 2024
- Modeling and control method of combined heat and power plant with integrated hot water storage tankApplied Thermal Engineering, 2023
- Flexible Operation Mode of Coal-fired Power Unit Coupling with Heat Storage of Extracted Reheat SteamJournal of Thermal Science, 2022
- CO2 mitigation accounting for Thermal Energy Storage (TES) case studiesApplied Energy, 2015
- Hourly energy analysis and feasibility study of employing a thermocline TES system for an integrated CHP and DH networkEnergy Conversion and Management, 2013
- Simulation of Air Quality using an ISCST3 Dispersion ModelCLEAN – Soil, Air, Water, 2008
- Improvement of the cogeneration plant economy by using heat accumulatorEnergy, 2006
- Apheis: Health Impact Assessment of Long-term Exposure to PM2.5 in 23 European CitiesEuropean Journal of Epidemiology, 2006
- Life cycle energy requirements and greenhouse gas emissions from large scale energy storage systemsEnergy Conversion and Management, 2004