Determination of the Partition Coefficient for the Grinding of a HardWC-Co-CrCoating with a Diamond Wheel
- 2 October 2014
- journal article
- research article
- Published by Taylor & Francis in Machining Science and Technology
- Vol. 18 (4) , 585-602
Abstract
□ Determination of the partition ratio is fundamental to a thermo-mechanical approach to the grinding process. To establish the energy balance, accurate measurements and numerical modelling must be combined. In this work, such a method is applied to the grinding of a HVOF WC-Cr-Co hard coating. A double pole grindable thermocouple was developed to measure the temperature in the arc of cut, and its effective length. The heat flux absorbed by the workpiece is found by fitting the numerical solution to the temperature profile measured during the cooling phase, behind the contact. Identical results for the heat flux may be obtained by fitting the results to the analytical solution from moving heat source theory, but the maximum interface temperature is underestimated. A finite element solution, using MSC Marc software allows a closer approach to the maximum temperature measured at the interface during grinding, provided that the thickness of the coating is correctly modelled.Keywords
This publication has 17 references indexed in Scilit:
- OPTIMIZATION OF DRESSING CONDITIONS FOR A RESIN-BONDED DIAMOND WHEEL BY TOPOGRAPHY ANALYSISMachining Science and Technology, 2013
- Measurement of grinding temperatures using a foil/workpiece thermocoupleInternational Journal of Machine Tools and Manufacture, 2012
- A study of plane surface grinding under minimum quantity lubrication (MQL) conditionsInternational Journal of Machine Tools and Manufacture, 2010
- Experimental validation of numerical thermal models for dry grindingJournal of Materials Processing Technology, 2008
- EXPERIMENTAL ANALYSIS OF TEMPERATURE IN GRINDING AT THE GLOBAL AND LOCAL SCALESMachining Science and Technology, 2008
- Comparison of numerically and analytically predicted contact temperatures in shallow and deep dry grinding with infrared measurementsInternational Journal of Machine Tools and Manufacture, 2008
- Numerical analysis of grinding temperature measurement by the foil/workpiece thermocouple methodInternational Journal of Machine Tools and Manufacture, 2006
- Mist jet cooling of grinding processesInternational Journal of Machine Tools and Manufacture, 2005
- Heat transfer during HVOF depositionSurface and Coatings Technology, 1998
- Analysis of Transient Temperatures in GrindingJournal of Engineering for Industry, 1995