CCAT: LED Mapping and Characterization of the 280 GHz TiN KID Array
- 16 December 2024
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 35 (5) , 1-4
Abstract
Prime-Cam, one of the primary instruments for the Fred Young Submillimeter Telescope (FYST) developed by the CCAT Collaboration, will house up to seven instrument modules, with the first operating at 280 GHz. Each module will include three arrays of superconducting microwave kinetic inductance detectors (KIDs). The first KID array fabricated for the 280 GHz module uses titanium-nitride (TiN) as the superconducting material and has 3,456 individual detectors, while the other two arrays use aluminum. This paper presents the design and laboratory characterization of the 280 GHz TiN array, which is cooled below its critical temperature to $\sim$ 0.1K and read out over six RF feedlines. LED mapping, a technique for matching the measured resonant frequency of a detector to its physical position, was performed on the array so that the results can be used to lithographically trim the KID capacitors and increase the yield of the array by reducing frequency collisions. We present the methods and results of LED mapping the 280 GHz TiN KID array before deployment on FYST.Keywords
All Related Versions
This publication has 8 references indexed in Scilit:
- CCAT-prime Collaboration: Science Goals and Forecasts with Prime-Cam on the Fred Young Submillimeter TelescopeThe Astrophysical Journal Supplement Series, 2022
- CCAT-prime: design of the Mod-Cam receiver and 280 GHz MKID instrument module2022
- CCAT-Prime: Characterization of the First 280 GHz MKID Array for Prime-CamJournal of Low Temperature Physics, 2022
- CCAT-prime: Designs and status of the first light 280 GHz MKID array and mod-cam receiver2020
- Sensitivity of the Prime-Cam Instrument on the CCAT-Prime TelescopeJournal of Low Temperature Physics, 2020
- Prime-Cam: a first-light instrument for the CCAT-prime telescope2018
- Superconducting micro-resonator arrays with ideal frequency spacingApplied Physics Letters, 2017
- An Open Source, FPGA-Based LeKID Readout for BLAST-TNG: Pre-Flight ResultsJournal of Astronomical Instrumentation, 2016