Analysis of Q-Factor for AM-SLM Cavity Based Resonators Using Surface Roughness Models
- 16 January 2024
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal on Multiscale and Multiphysics Computational Techniques
- Vol. 9, 75-83
Abstract
This research delves into losses of X-band cavity resonators manufactured using additive manufacturing-selective laser melting (AM-SLM) compared to the standard subtractive manufacturing milling technology. Measured losses are benchmarked in terms of resonator (quality) $Q$ -factor. The measured data is further modelled using the Groiss and one-ball Huray models taking into account the implications of surface roughness and electrical conductivity. The unloaded $Q$ -factor is derived from frequency-dependent scattering ( $S$ ) parameters obtained from measurements and full-wave simulations. Surface roughness was found to impact the $Q$ -factor significantly and the resonant frequency marginally. Cavities based on AM-SLM technology exhibit higher roughness compared to milling and lowers the $Q$ -factor. A fusion of both manufacturing methods by milling AM-SLM cavity walls demonstrates an augmented $Q$ -factor compared to a directly printed cavity. In the study it was also found that the Groiss model tends to overestimate the $Q$ -factor owing to AM-SLM's rougher surface, while the one-ball Huray model furnishes precise projections by establishing a link between surface roughness and powder particles. Electrical conductivity's influence on $Q$ -factor was also investigated, showing negligible impact with increased surface roughness. Further, side walls of the AM-SLM cavity were more susceptible to surface roughness, compared to the cavity front walls due to higher surface current density. This study underscores the significance of analyzing surface roughness and electrical conductivity in AM-SLM cavity resonators and highlights the suitability of the one-ball Huray model for accurate $Q$ -factor prediction of microwave structures with rough surfaces.Keywords
Funding Information
- Swedish Innovation Agency VINNOVA (2021-01328)
This publication has 29 references indexed in Scilit:
- Enhancing the Performance of Waveguide Filters Using Additive ManufacturingProceedings of the IEEE, 2016
- Microresonator for Microwave Cancer TherapyIEEE Journal on Multiscale and Multiphysics Computational Techniques, 2016
- Phase-Noise Analysis of an X-Band Ultra-Low Phase-Noise GaN HEMT Based Cavity OscillatorIEEE Transactions on Microwave Theory and Techniques, 2015
- Analysis of surface roughness of aluminum alloys fine turned: United phenomenological models and multi-performance optimizationMeasurement, 2015
- Extraction of Dielectric and Rough Conductor Loss of Printed Circuit Board Using Differential Method at Microwave FrequenciesIEEE Transactions on Microwave Theory and Techniques, 2014
- Fundamentals of a 3-D “snowball” model for surface roughness power losses2007
- Microwave filters with improved spurious performance based on sandwiched conductor dielectric resonatorsIEEE Transactions on Microwave Theory and Techniques, 2001
- Parameters of lossy cavity resonators calculated by the finite element methodIEEE Transactions on Magnetics, 1996
- Incremental Frequency Rule for Computing the Q-Factor of a Shielded TE/sub omp/ Dielectic Resonator (Short Papers)IEEE Transactions on Microwave Theory and Techniques, 1984
- Effect of Surface Roughness on Eddy Current Losses at Microwave FrequenciesJournal of Applied Physics, 1949