Pressure Sensitive Paint Visualization of Pressure Distribution of Externally Pressurized Circular Thrust Gas Bearing With a Single Gas Supply Hole: Experimental Validation of Variation of Pressure Distribution by Supply Pressure
- 6 April 2017
- journal article
- Published by ASME International in Journal of Tribology
- Vol. 139 (5) , 054501
Abstract
This study investigated the use of pressure sensitive paint (PSP) as new measuring technique for measuring the pressure distribution of a gas bearing. An externally pressurized circular thrust gas bearing with single gas supply hole was used as the test bearing to investigate the suitability of this technique. The test bearing was 30 mm in diameter, with a gas supply hole of diameter 0.7 mm. A coat of PtTFPP, the substance used as the PSP, was applied to the bearing surface using an air-assisted spray. The PSP luminescence characteristics were calibrated before the tests because of their dependency on temperature and pressure. The pressure distribution was obtained by averaging 50 images captured by a 12-bit complementary metal-oxide semiconductor (CMOS) camera. These experimental results were compared with the results of a numerical analysis based on the divergence formulation method. There was good agreement between the experimental and analytical results, thus demonstrating the effectiveness of using PSP for pressure distribution measurements.Keywords
This publication has 13 references indexed in Scilit:
- Numerical Analysis of Hydroinertia Gas Bearings with Inclined Supply Holes for High-Speed Rotary MachinesInternational Journal of Mechanical Engineering and Applications, 2014
- Pressure-sensitive channel chip for visualization measurement of micro gas flowsMicrofluidics and Nanofluidics, 2011
- Numerical investigation of static and dynamic characteristics of aerostatic thrust bearings with small feed holesTribology International, 2010
- Pressure-sensitive molecular film for investigation of micro gas flowsMicrofluidics and Nanofluidics, 2010
- Influence of orifices on stability of rotor-aerostatic bearing systemTribology International, 2009
- PSP visualization studies on a convergent nozzle with anJournal of Visualization, 2009
- Numerical Calculations of Pressure Distribution in the Bearing Clearance of Circular Aerostatic Thrust Bearings With a Single Air Supply InletJournal of Tribology, 2006
- Performance analysis of high-speed spindle aerostatic bearingsTribology International, 2005
- Numerical and experimental analysis of aerostatic thrust bearings with porous restrictorsTribology International, 2004
- A Study on Run-Out Characteristics of Externally Pressurized Gas Journal Bearing : Rotor Run-Out CharacteristicsJSME International Journal. Ser. C, Dynamics, Control, Robotics, Design and Manufacturing, 1994