Abstract
This study refines the process that defines the microstructure and mechanical properties of samples manufactured by additive electron-beam melting (EBM) from the titanium alloy VT6 powder of the Ti-6Al-4V system. The task addressed is to establish regularities in the VT6 alloy structuring, thereby determining the relationship between the parameters of the additive process, the αʹ-phase morphology, defectivity, and mechanical properties. The spherical titanium alloy VT6 powder with a particle size of 40–160 μm was used as the raw material. 50 samples measuring 25 × 25 mm and 7.5 mm high were studied. For an electron beam energy density of 15–40 J/mm3 in the range of scanning speeds from 500 mm/s to 12000 mm/s, technological modes were determined that ensure a smooth surface morphology of articles. It is noted that the material of the samples is characterized by a layered structure with a uniform chemical composition. The microstructure of grains in the deposited metal in all samples consists of a lamellar αʹ-phase and a small amount of β-phase. The sizes of lamellar components vary depending on the technological parameters. The microhardness level is in the range HV = 192.1…392.42 with a relatively uniform distribution of values. The following rational printing modes have been established: 500 mm/s / 40 J/mm3, 4000 mm/s / 24 J/mm3, 6000 mm/s / 18 J/mm3, and 8000 mm/s / 16 J/mm3. They enable the formation of a structural state of the metal with minimal defects, a dispersed α′-structure, and a uniform distribution of microhardness. The results demonstrate that the combination of high-quality powder material and rational printing mode provides high process reproducibility, structural stability, and suitability of the technology for manufacturing articles with predicted characteristics