Inaudible Knock and Partial-Burn Detection Using In-Cylinder Ionization Signal
Authors:
- 27 October 2003
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
Internal combustion engines are designed to maximize power subject to meeting exhaust emission requirements and minimizing fuel consumption. Maximizing engine power and fuel economy is limited by engine knock for a given air-to-fuel charge. Therefore, the ability to detect engine knock and run the engine at its knock limit is a key for the best power and fuel economy. This paper shows inaudible knock detection ability using in-cylinder ionization signals over the entire engine speed and load map. This is especially important at high engine speed and high EGR rates. The knock detection ability is compared between three sensors: production knock (accelerometer) sensor, in-cylinder pressure and ionization sensors. The test data shows that the ionization signals can be used to detect inaudible engine knock while the conventional knock sensor cannot under some engine operational conditions. Detection of inaudible knock is important since it will improve the existing knock control capability to allow the engine run at its inaudible knock limit. Partial-burn detection using ionization is also shown in this paper. A comparison of both in-cylinder pressure and ionization sensor signals are used in this analysis. The test results show that some light partial-burn cases can only be detected by ionization signals. The partial-burn information appears to be difficult to observe under some conditions using the pressure trace directly.Keywords
This publication has 12 references indexed in Scilit:
- Application of Different Cylinder Pressure Based Knock Detection Methods in Spark Ignition EnginesSAE International Journal of Advances and Current Practices in Mobility, 2002
- Computing The Optimum Knock Sensor LocationsSAE International Journal of Advances and Current Practices in Mobility, 2002
- Estimation of Combustion Variability Using In-cylinder Ionization MeasurementsSAE International Journal of Advances and Current Practices in Mobility, 2001
- Limitations of Ionization Current Sensors and Comparison with Cylinder Pressure SensorsSAE International Journal of Advances and Current Practices in Mobility, 2000
- Ion Current Sensing for Spark Ignition EnginesSAE International Journal of Advances and Current Practices in Mobility, 1999
- Evaluation of the Effect of EGR on Engine KnockSAE International Journal of Advances and Current Practices in Mobility, 1998
- The Application of Ionic Current Detection System for the Combustion Limit ControlSAE International Journal of Advances and Current Practices in Mobility, 1998
- Application of Vehicle Equipped with Ionic Current Detection System for the Engine Management SystemSAE International Journal of Advances and Current Practices in Mobility, 1997
- In-Cylinder Pressure Measurements Using the Spark Plug as an Ionization SensorSAE International Journal of Advances and Current Practices in Mobility, 1997
- Ion-Gap Sense in Misfire Detection, Knock and Engine ControlSAE International Journal of Advances and Current Practices in Mobility, 1995