Abstract
The dispersion stability of catalyst inks and the cell performance of the resulting catalyst layer in polymer electrolyte fuel cells are influenced by the type of platinum-supported carbon (Pt/C) used. However, the specific effects of Pt/C properties remain unclear. In this study, we focus on the effect of Pt/C aggregate size and investigate its impact on the formation of colloidal gel in catalyst inks—a stable agglomerate structure that contributes to dispersion stability—as well as on the resulting cell performance. To achieve this, the aggregate size was controlled by varying the number of ball milling (BM) cycles: 1, 5, and 10. When the aggregate size is large (1 and 5 BM cycles), colloidal gel formation is hindered because the limited outer surface area of larger aggregates reduces ionomer adsorption, weakening electrostatic repulsion (Fig. 1, top). As a result, sedimentation of Pt/C dominates over Brownian motion. Additionally, restricted ionomer penetration into larger aggregates limits ion conduction pathways, leading to low platinum utilization and suboptimal cell performance (Fig. 2). In contrast, when the Pt/C aggregate size is small (10 BM cycles), colloidal gel formation is promoted because the increased outer surface area enhances ionomer adsorption and strengthens electrostatic repulsion (Fig. 1, bottom). As a result, Brownian motion dominates over sedimentation. Moreover, the smaller aggregates allow more platinum sites to become accessible to the ionomer, enhancing catalyst utilization and improving cell performance (Fig. 2). Figure 1