Abstract
In order to meet the demand for high-sensitivity pressure detection, this paper proposes a design method for a fiber Bragg grating (FBG) pressure sensor based on a diaphragm-lever composite structure. By constructing a diaphragm deformation-lever displacement amplification mechanism, the pressure sensitivity of the sensor is effectively improved. Firstly, a theoretical model for the transmission of pressure signal-diaphragm deformation displacement-lever displacement amplification-FBG strain wavelength shift is established. The sensor sensitivity is theoretically analyzed through a geometric model, and it is concluded that the theoretical amplification ratio of the diaphragm-lever composite structure is 3.464, with a sensitivity of 84.101 nm/MPa. Then, SolidWorks is used for sensor design and modeling, and the Ansys simulation platform is employed for iterative optimization to determine structural parameters such as grating diameter and length. Finite element analysis is used to simulate and calculate the amplification ratio and sensitivity, yielding a simulated amplification ratio of 3.229 and a sensitivity of 78.091 nm/MPa. These results are highly consistent with the theoretical analysis, verifying the reliability of the theoretical model. Finally, a physical sensor is fabricated according to the optimized structure, and packaging and testing systems are built to complete the characteristic testing of the sensor. Experimental results show that within the range of 0-0.1 MPa, the amplification ratio of the diaphragm-lever composite structure is 2.841, and the pressure sensitivity is 69.042 nm/MPa, which are basically consistent with the theoretical and simulation results. The linearity is 99.9%, and the repeatability error and hysteresis error are 1.160% and 0.623%, respectively.
Funding Information
  • National Key Research and Development Program of China (2021YFA1003504)

This publication has 22 references indexed in Scilit: