Constant Off-Time-Based Current-Balancing Technique With Accuracy and Transient Optimization in Wide I/O Range for Multi-Phase Regulator
- 24 July 2025
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 72 (11) , 6493-6504
Abstract
A constant off-time (COFT) based current-balancing (CB) technique is proposed for integrated multi-phase DC-DC switching regulators with wide input/output (I/O) voltage range. The small-signal characteristics and design criteria of the proposed technique are derived based on describing functions. The current-balancing accuracy of the proposed technique depends merely on the ratio between the sensing FETs and the corresponding power switches ( $\alpha $ ), while the requirement on absolute equivalent sensing-resistances ( $R_{\mathrm {i}}$ ) and the matching of sensing circuits among phases are relaxed. Meanwhile, both the proposed current-balancing behavior and the adjustment of phase number will not affect the stability and the transient behavior of the multi-phase system. Furthermore, as a crucial block of the COFT control scheme, the proposed self-tuning PLLs of clock synchronization loop can remain fixed bandwidth under different I/O voltages, which further enhance the system stability. Therefore, in principle, the phase-interleaving with fixed switching frequency can be realized without the limit of duty cycle. As a result, the proposed CB technique can alleviate the stringent matching requirement of layout in conventional multi-phase systems, as well as the loop compensation difficulty. It is verified by an integrated dual-phase regulator fabricated in a $0.18\mu $ m BCD process. Experimental results show that the regulator can provide 0.9-1.8V output from a 2.3-5.5V input at both steady state and load-transient state with significantly higher performance by the proposed CB technique, ensuring current-imbalance ratio within ±1.3%.
Keywords
Funding Information
- Natural Science Foundation of China (U22A2013)
This publication has 25 references indexed in Scilit:
- A 1.23W/mm2 83.7%-Efficiency 400MHz 6-Phase Fully Integrated Buck Converter in 28nm CMOS with On-Chip Capacitor Dynamic Re-Allocation for Inter-Inductor Current Balancing and Fast DVS of 75mV/ns2022
- Sampling Delay Effect on Stability in a Multi-Phase Buck Converter using Digital Current Mode Control2021
- A Scalable Multiphase Current-Mode Buck Controller With Sub-Milliohm DCR Current Sensing and Synchronized Overcurrent ProtectionIEEE Journal of Solid-State Circuits, 2021
- A Current-Density-Enhanced 12V-to-1.2V/10A, AOT-Controlled, 4-Phase Series-Capacitor Buck Converter with Embedded Current Balancing2019
- A Digital Multiphase Converter with Sensor-less Current and Thermal Balance Mechanism2018
- A Four-Phase Buck Converter With Capacitor-Current-Sensor Calibration for Load-Transient-Response Optimization That Reduces Undershoot/Overshoot and Shortens Settling Time to Near Their Theoretical LimitsIEEE Journal of Solid-State Circuits, 2017
- Current‐balance method for multi‐phase DC–DC buck converters with wide duty ratio applications in both CCM and DCMElectronics Letters, 2017
- 10.6 A 30MHz hybrid buck converter with 36mV droop and 125ns 1% settling time for a 1.25A/2ns load transient2017
- Analysis and design of a fully-integrated current sharing scheme for multi-phase adaptive on -time modulated switching regulators2008 IEEE Power Electronics Specialists Conference, 2008
- Padé Approximants Second Edition1996