Nanoindentation creep behavior of grain boundary in pure magnesium
- 6 September 2010
- journal article
- research article
- Published by Taylor & Francis in Philosophical Magazine Letters
- Vol. 90 (12) , 883-890
Abstract
Nanoindentation creep tests were performed at the grain boundary and grain interior in pure magnesium. The grain boundary showed a high strain rate sensitivity exponent and was dominated by grain boundary sliding due to the high diffusion rate at the grain boundary. The grain boundary affected the deformation behavior of the area at a distance of 2 µm into the grain interior. On the other hand, the grain interior had a low strain rate sensitivity exponent, because its matrix was too large to be influenced by the grain boundary. The deformation mechanism in the grain interior was determined to be dislocation slip.Keywords
This publication has 30 references indexed in Scilit:
- Evaluation of matrix strength in ultra-fine grained pure Al by nanoindentationJournal of Materials Research, 2009
- Intragranular Deformation Mechanisms during Ambient-Temperature Creep in Hexagonal Close-Packed MetalsMATERIALS TRANSACTIONS, 2009
- Critical examination of strain-rate sensitivity measurement by nanoindentation methods: Application to severely deformed niobiumActa Materialia, 2008
- On the elastic effects in power-law indentation creep with sharp conical indentersJournal of Materials Research, 2008
- Fracture toughness in direct extruded Mg–Al–Zn alloysJournal of Materials Research, 2007
- Measuring the strain rate sensitivity by instrumented indentation. Application to an ultrafine grain (equal channel angular–pressed) eutectic Sn–Bi alloyJournal of Materials Research, 2004
- Nanoindentation creep of single-crystal tungsten and gallium arsenidePhilosophical Magazine A, 1997
- The relationship between indentation and uniaxial creep in amorphous seleniumJournal of Materials Research, 1995
- Elastic-Plastic Analysis of Triangular Pyramidal Indentation.TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A, 1993
- An improved technique for determining hardness and elastic modulus using load and displacement sensing indentation experimentsJournal of Materials Research, 1992