Formation of non-metallic inclusions in production of 08Kh18N10T corrosion-resistant steel
Open Access
- 20 October 2024
- journal article
- Published by National University of Science and Technology MISiS in Izvestiya. Ferrous Metallurgy
- Vol. 67 (5) , 549-555
Abstract
Corrosion-resistant steels are in demand in the modern world due to their high performance properties and a wide range of applications. Such areas of application include kitchenware, furniture, medical equipment, nuclear reactors, spacecraft, etc. Oxygen in steel, especially in corrosion-resistant steel, is one of the most harmful elements. Oxide inclusions disrupt the homogeneity of the metal, negatively affect the ductility, fracture toughness, fatigue strength and corrosion resistance of steel. In corrosion-resistant steels, non-metallic inclusions (NI) lead to the formation of defects in cold-rolled sheets. Aluminate inclusions also lead to clogging of steel-casting equipment. An analysis of the production technology of corrosion-resistant steel 08Kh8N10T was carried out in order to determine the causes of NI formation that affect the pourability of steel and its quality. The studies determined the content of total oxygen and nitrogen, as well as oxygen bound in various non-metallic inclusions at the stages of ladle processing and continuous steel casting. It was shown that after the introduction of titanium wire into the melt, the total nitrogen content decreases due to the formation and subsequent removal of titanium nitrides. At the same time, the content of titanium oxides in the melt increases. It was shown that the causes of clogging of steel-pouring nozzles during continuous casting are complex non-metallic inclusions based on titanium oxides, which were deposited on the inner surface of the pouring nozzle-doser. Recommendations were made to adjust the technology of steel melting in EAF and ladle processing. Based on the results of electron microscopic analysis, it was established that mixing of refining liquid-mobile slag in ladle steel processing units contributed to the assimilation of non-metallic inclusions by slag and a decrease in their sizes in the metal. After the implementation of the corrective recommendations, clogging of steel-pouring nozzles during continuous casting was not observed.Keywords
This publication has 12 references indexed in Scilit:
- Review of Processing Maps and Development of Qualitative Processing MapsMaterials Today: Proceedings, 2017
- STUDY OF “CAKE” DEFECT IN CONTINUOUSLY CAST AUSTENITIC STAINLESS STEEL 18CR-10NI-1TI. REPORT 1Izvestiya. Ferrous Metallurgy, 2015
- Nucleation, Growth, Transport, and Entrapment of Inclusions During Steel CastingJOM, 2013
- Study of rolling contact fatigue of bearing steels in relation to various oxide inclusionsMaterials & Design (1980-2015), 2011
- Numerical Model of Thermal and Flow Phenomena the Process Growing of the CC SlabArchives of Metallurgy and Materials, 2011
- Kinetic Modeling on Nozzle Clogging During Steel Billet Continuous CastingISIJ International, 2010
- State of the art in the control of inclusions during steel ingot castingMetallurgical and Materials Transactions B, 2006
- Indirect Methods of Detecting and Evaluating Inclusions in Steel—A ReviewJournal of Iron and Steel Research International, 2006
- Mechanism of Alumina Adhesion to Continuous Caster Nozzle with Reoxidation of Molten Steel.ISIJ International, 2001
- Formation of Clogging Materials in an Immersed Nozzle during Continuous Casting of Titanium Stabilized Stainless Steel.ISIJ International, 1993