The relations between wear behavior and basic material properties of graphene‐based materials reinforced ultrahigh molecular weight polyethylene
- 29 June 2021
- journal article
- research article
- Published by Wiley in Polymers for Advanced Technologies
- Vol. 32 (11) , 4263-4281
Abstract
This article aims to investigate the influence of reinforcing graphene oxide (GO) and graphite flakes (GF) fillers into ultrahigh molecular weight polyethylene (UHMWPE) for orthopedic application. These fillers were expected to physically bond to UHMWPE, thus can enhance the subsurface strength, improving the wear behavior of the composites. UHMWPE/GO and UHMWPE/GF composites were prepared at 0.1 and 1.0 wt% by melt‐blending, followed by a compression molding technique. A multidirectional pin‐on‐disc wear test was performed to simulate the kinematic of hip application. Whilst getting exposed in the artificial in‐vivo lubricant bath (30 v/v% diluted bovine serum). Following this, the wear mechanism fostered by each filler (GO and GF) was determined by wear features obtained from the optical microscope and scanning electron microscope (SEM). The crystallinity degree and crystal defect were assessed using x‐ray diffraction (XRD). The mechanical properties of fabricated composites were evaluated by using a universal testing machine and Vickers microhardness. We found that UHMWPE/GO has the lowest specific wear rate due to the improved subsurface strength, as the reduction of a weak adhesive point was observed on the worn surface. Meanwhile, higher GF content (1 wt%) in UHMWPE displayed a lower specific wear rate than neat UHMWPE after completing the 10 km sliding distance attributed to the filler resurfaced, responsible for providing a strong resistance of the shear stress applied upon sliding with the metal counterface. Interestingly, the hardness and tensile strength for both UHMWPE/GO and UHMWPE/GF increased, although the crystallinity percentage was declining compared to neat UHMWPE.Keywords
This publication has 63 references indexed in Scilit:
- Risk of Subsequent Revision after Primary and Revision Total Joint ArthroplastyClinical Orthopaedics and Related Research, 2010
- Polyethylene damage and deformation on fixed-bearing, non-conforming unicondylar knee replacements corresponding to progressive changes in alignment and fixationClinical Biomechanics, 2010
- Well-Dispersed Fractal Aggregates as Filler in Polymer−Silica Nanocomposites: Long-Range Effects in RheologyMacromolecules, 2009
- Recycled carbon fiber filled polyethylene compositesJournal of Applied Polymer Science, 2007
- Failure analysis on retrieved ultra high molecular weight polyethylene (UHMWPE) acetabular cupsEngineering Failure Analysis, 2007
- Polymer Nanocomposites Containing Carbon NanotubesMacromolecules, 2006
- Free abrasive wear behavior of UHMWPE composites filled with wollastonite fibersComposites Part A: Applied Science and Manufacturing, 2006
- Aseptic loosening, not only a question of wear: A review of different theoriesActa Orthopaedica, 2006
- Effects of contact area and stress on the volumetric wear of ultrahigh molecular weight polyethyleneWear, 2003
- Wear behavior of bulk oriented and fiber reinforced UHMWPEWear, 2000