Microstructure Features and Mechanical Properties of Modified Low-Activation Austenitic Steel in the Temperature Range of 20 to 750 °C
Authors:
Open Access
Abstract
A new low-activation austenitic steel with a modified composition and high austenite stability is proposed. The features of its microstructure after solution treatment (ST) and cold rolling (CR) are studied. The mechanical properties and features of the fracture behavior of this steel under tensile tests in the temperature range of 20–750 °C are discussed. After ST, an austenitic structure with stacking faults and dispersed carbide particles of the MC and M23C6 types is observed in the steel. After CR, the grains are refined, and the average grain size decreases from 41.4 µm (after ST) to 33.9 µm. High-density microtwin packets form in the material, and the dislocation density increases relative to that after ST. As the test temperature increases from 20 to 750 °C, the yield strength of the steel decreases by approximately two times, from ≈300 to 150 MPa (for ST) and from ≈700 to 370 MPa (for CR). In the studied temperature range, the steel demonstrates up to 2.6 times higher values of elongation to failure, ≈40–80% (for ST) and ≈13–27% (for CR), compared to steels of similar compositions and lower manganese content. Mechanical twinning contributes to the high steel ductility up to 300 °C. Signs of discontinuous flow in the tensile curves after ST in the temperature range of 500–600 °C and a decrease in the elongation to failure in the close temperature range indicate dynamic strain aging (DSA). Steel fracture after tension at all test temperatures mainly occurs via a ductile dimple transcrystalline mechanism with elements of ductile intercrystalline fracture. It is shown that cracks nucleate on clusters of dispersed second-phase particles. The mechanisms of plastic deformation, fracture, and strengthening of the proposed modified low-activation austenitic steel are discussed.Keywords
Funding Information
- Russian Science Foundation (22-19-00802)
This publication has 24 references indexed in Scilit:
- Critical assessment: Martensite-start temperature for the transformationCalphad, 2012
- Radiation creep and phase instability of low-activation austenitic steel 12 Cr-20 Mn-W under neutron irradiation in the FFTF fast reactorInorganic Materials: Applied Research, 2011
- Reduced activation Fe-Cr-Mn austenitic steels for nuclear power plantsInorganic Materials: Applied Research, 2010
- A Review on the Potential Use of Austenitic Stainless Steels in Nuclear Fusion ReactorsJournal of Fusion Energy, 2008
- Low activation austenitic Mn-steel for in-vessel fusion materialsJournal of Nuclear Materials, 1998
- Tensile behavior of irradiated manganese-stabilized stainless steelsJournal of Nuclear Materials, 1996
- Phase stability of reduced-activation Mn-stabilized austenitic steelsJournal of Nuclear Materials, 1992
- Tensile and microstructural behavior of solute-modified manganese-stabilized austenitic steelsMaterials Science and Engineering: A, 1990
- Phase instabilities in irradiated simple Fe-Cr-Mn low activation alloysJournal of Nuclear Materials, 1988
- Manganese as an austenite stabilizer in FeCrMnC steelsMaterials Science and Engineering: A, 1988