Influence of the Deposition Process and Substrate on Microstructure, Phase Composition, and Residual Stress State on As-Deposited Cr-Al-C Coatings
Authors:
- Stefan HeinzeSHStefan Heinze
- Tim KrülleTKTim Krülle
- Lars EwenzLELars Ewenz
- Christina KrywkaCKChristina Krywka
- Anton DavydokADAnton Davydok
- Andreas StarkASAndreas Stark
- Rainer CremerRCRainer Cremer
- Christoph LeyensCLChristoph Leyens
Preprint
- 17 July 2022
- preprint
- Published by Elsevier in SSRN Electronic Journal
Abstract
This paper focuses on the influence of the deposition process, deposition parameters, and substrate on various properties of the as-deposited state of Cr-Al-C thin films deposited by Direct Current Magnetron Sputtering (DCMS) and High Power Pulsed Magnetron Sputtering (HPPMS) with the variation of bias voltage and deposition temperature. Three substrates with different coefficients of thermal expansion and electrical conductivity were used. To investigate the microstructure, phase composition, residual stress state, and mechanical properties, ex-situ and in-situ synchrotron experiments were conducted accompanied by electron microscopy and nanoindentation. As-deposited Cr-Al-C coatings consisted of amorphous and crystalline areas, with the ratio highly dependent on the deposition process and substrate. The crystalline phase was identified as metastable (Cr,Al)2C. The highest crystallinity was determined for DCMS coatings. Increasing temperature and decreasing bias voltage increased coating crystallinity for HPPMS coatings. The influence of the deposition process and bias voltage was highly reduced for the substrate with low electrical conductivity. In-situ investigations of the stress state of amorphous areas revealed, that those were acting as a residual stress buffer. The hardness and Young’s modulus of the coatings were found to increase with crystallinity and were slightly increased for crystalline HPPMS coatings compared to DCMS coatings.Keywords
This publication has 38 references indexed in Scilit:
- Origins of microstructure and stress gradients in nanocrystalline thin films: The role of growth parameters and self-organizationActa Materialia, 2013
- Phase formation and microstructure evolution of arc ion deposited Cr2AlC coating after heat treatmentApplied Surface Science, 2012
- Size effect of thermal expansion and thermal/intrinsic stresses in nanostructured thin films: Experiment and modelActa Materialia, 2011
- The origin of stresses in magnetron-sputtered thin films with zone T structuresActa Materialia, 2010
- Calculation of the surface energy of hcp-metals with the empirical electron theoryApplied Surface Science, 2009
- High-temperature oxidation and hot corrosion of Cr2AlCActa Materialia, 2007
- Effect of the Composition on the Structure of Cr‐Al‐C Investigated by Combinatorial Thin Film Synthesis and ab Initio CalculationsAdvanced Engineering Materials, 2004
- A simple model for the formation of compressive stress in thin films by ion bombardmentThin Solid Films, 1993
- Stress-related effects in thin filmsThin Solid Films, 1989
- A systematic investigation of elastic moduli of Wc-Co alloysMetallurgical Transactions, 1970