Minor cutting edge angles of sawing teeth: effect on cutting forces in wood
Open Access
- 11 June 2022
- journal article
- research article
- Published by Springer Nature in European Journal of Wood and Wood Products
- Vol. 80 (5) , 1165-1173
Abstract
Optimising the cutting tool geometries can reduce waste while increasing timber yield. The industry is moving towards thin-kerf bandsawing of timber, and therefore, the geometry of the minor cutting edge and minor first flanks of cutting teeth become more important. Six cutting teeth with varying minor cutting edge angles ( $$0^{\circ }$$ , $$2^{\circ }$$ , $$4^{\circ }$$ , $$6^{\circ }$$ ) and minor cutting edge clearance angles ( $$2^{\circ }$$ , $$4^{\circ }$$ , $$6^{\circ }$$ ) were tested by cutting into the heartwood and sapwood of frozen and non-frozen Norway spruce (Picea abies (L.) Karst.) and Scots pine (Pinus sylvestris L.). Single cutting tooth tests were conducted, and the cutting and feeding forces were measured. The cutting forces were higher for Scots pine due to its higher density. Frozen sapwood resulted in higher cutting forces. The feeding force of frozen sapwood stood out as it was highly negative (i.e. self-feeding) compared to frozen heartwood, non-frozen heartwood and non-frozen sapwood. An increase in the minor cutting edge angle and minor cutting edge clearance angles, and therefore more room for elastic spring-back, can lead to up to less friction and 40% lower cutting forces. Higher minor cutting edge angles and minor cutting edge clearance angles resulted in less-negative feeding forces (i.e. less self-feeding) for frozen sapwood but remained relatively unchanged for the other wood conditions.
Keywords
Funding Information
- BioInnovation (2017-02697)
- VINNOVA
- Energimyndigheten
- Svenska Forskningsrådet Formas
- Lulea University of Technology
This publication has 14 references indexed in Scilit:
- Cutting force analysis of a linear cutting process of spruceWood Material Science & Engineering, 2017
- The influences of circular saws with sawteeth of mic-zero-degree radial clearance angles on surface roughness in wood rip sawingAnnals of Forest Science, 2017
- Sawing Processes as a Way of Determining Fracture Toughness and Shear Yield Stresses of WoodBioResources, 2015
- Effects of temperature and moisture content on selected wood mechanical properties involved in the chipping processWood Science and Technology, 2014
- Cutting forces in bandsaw processing of oak and beech wood as affected by wood moisture content and cutting directionsEuropean Journal of Wood and Wood Products, 2013
- Application of fracture mechanics for energetic effects predictions while wood sawingWood Science and Technology, 2013
- Economical Wood Sawing with Circular Saw Blades of a New DesignDrvna industrija, 2012
- A fracture mechanics analysis of cutting and machiningEngineering Fracture Mechanics, 2010
- Clinical implications of dysregulated cytokine productionJournal of Molecular Medicine, 2000
- Studies of the main cutting force at and near a cutting edgeEuropean Journal of Wood and Wood Products, 1993