Ultrasonic and Eddy-Current Fatigue Monitoring of Austenitic Steel Welded Joints
Open Access
- 1 July 2021
- journal article
- research article
- Published by Pleiades Publishing Ltd in Russian Journal of Nondestructive Testing
- Vol. 57 (7) , 570-578
Abstract
We investigated the process of fatigue damage in welded joints made of austenitic steel by ultrasonic and eddy current types of testing. The development of an inhomogeneity in the distribution of the acoustic anisotropy parameter in the heat-affected zone and in the base material was studied. As a result of eddy current testing, the difference in the intensity of changes in the phase composition in the heat-affected zone and in the base material is shown. A linear relationship is obtained between the amplitude of the cycle deformation under regular loading in the low-cycle fatigue region and the critical value of the percentage of the magnetic phase in the base material. A method is proposed for assessing the fatigue damage to the material of welded joints in the heat-affected zone based on the results of eddy current testing.Keywords
This publication has 20 references indexed in Scilit:
- Ultrasonic estimation of the residual stressesInorganic Materials, 2014
- Effect of Heat Treatment on Deformation Induced Martensite in Austenitic Stainless SteelKey Engineering Materials, 2012
- Monitoring of Martensitic Transformation in Austenitic Stainless Steel 304 L by Eddy CurrentsResearch in Nondestructive Evaluation, 2010
- Eddy current detection of changes in stainless steel after cold reductionComputational Materials Science, 2008
- AISI 304 steel: anomalous evolution of martensitic phase following heat treatments at 400°CMaterials Science and Engineering: A, 2006
- Assessment of martensite content in austenitic stainless steel specimens by eddy current testingInsight - Non-Destructive Testing and Condition Monitoring, 2006
- Instruments for Magnetic Phase Analysis of Articles Made of Austenitic Corrosion-Resistant SteelsRussian Journal of Nondestructive Testing, 2005
- Ultrasonic velocities in anisotropic polycrystalline aggregatesJournal of Physics D: Applied Physics, 1982
- Effects of Strain State and Strain Rate on Deformation-Induced Transformation in 304 Stainless Steel: Part I. Magnetic Measurements and Mechanical BehaviorMetallurgical Transactions A, 1982
- Tensile properties of metastable stainless steelsJournal of Materials Science, 1972