Repeatability of Tests for Validation of Iron Loss Models in Electrical Machines
- 19 May 2023
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Magnetics
- Vol. 59 (11) , 1-10
Abstract
Prediction of iron loss in electrical machines is known to be a challenging task. The concept of a building factor to account for discrepancy between predicted and measured loss is widely used. From literature, these building factors may need to be as high as 1.5 to 2, i.e., a discrepancy of up to 100%, leading to different impact on total losses for every electrical machine. To calibrate the building factor, modelling and testing are required. This paper describes an extensive test campaign on PM synchronous machines at no-load with magnetized and dummy rotors. Several challenges to accurately quantify no-load iron loss by dynamic testing for model calibration are reported, highlighting the benefits of rotor temperatures monitoring, and performing repeatability checks. For accurate prediction of iron loss impacted by mechanical stress (due to cut edge damage or shrink-fit for example), advanced modelling approaches require electrical steel properties (BH and loss density) as function of tensile and compressive stress. Such measurements with a dedicated single sheet tester have not yet been standardized. Repeatability issues and spread of measured data are presented and their influence mitigated by a pre-cycling procedure. A novel method to compare the impact of stress on several electrical steel grades including thicknesses from 0.1 mm to 0.35 mm indicates different grades follow similar trends. However, the changes are grade-specific, requiring characterization of each material grade at multiple stress level, frequency, and flux density for advanced modelling of e-machine performance.Keywords
Funding Information
- Engineering and Physical Sciences Research Council (EPSRC) Studentship through Motor Design Ltd (1942187)
- Innovate U.K. Grants for projects Virbius (113168)
- COMPETE (113254)
- Prosperity Partnerships Enabling Low Carbon Technologies (EP/R004927/1)
This publication has 21 references indexed in Scilit:
- Mixed-Order Finite-Element Modeling of Magnetic Material Degradation Due to CuttingIEEE Transactions on Magnetics, 2018
- Effect of Punching the Electrical Sheets on Optimal Design of a Permanent Magnet Synchronous MotorIEEE Transactions on Magnetics, 2017
- Magnetic Materials Used in Electrical Machines: A Comparison and Selection Guide for Early Machine DesignIEEE Industry Applications Magazine, 2017
- Quantifying Effects of Cutting and Welding on Magnetic Properties of Electrical SteelsIEEE Transactions on Industry Applications, 2017
- Effect of Compressive Stress on Iron Loss of Gradient Si Steel SheetElectronics and Communications in Japan, 2016
- Design of IPMSM Applying V-Shape Skew Considering Axial Force Distribution and Performance Characteristics According to the Rotating DirectionIEEE Transactions on Applied Superconductivity, 2016
- Loss Analysis of Induction Motors by Considering Shrink Fitting of Stator HousingsIEEE Transactions on Magnetics, 2015
- Iron Loss Deterioration by Shearing Process in Non-Oriented Electrical Steel with Different Thicknesses and Its Influence on Estimation of Motor Iron LossIEEJ Journal of Industry Applications, 2014
- Effect of shrink fitting and cutting on iron loss of permanent magnet motorJournal of Magnetism and Magnetic Materials, 2008
- Motor Core Iron Loss Analysis Evaluating Shrink Fitting and Stamping by Finite-Element MethodIEEE Transactions on Magnetics, 2007