Single-Phase and Evaporating Two-Phase Flow Microchannel Cooling of Power Modules for Temporary Overcurrent Operation
- 9 June 2025
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 40 (10) , 15381-15398
Abstract
Evaporating two-phase flows are usually avoided in cooling applications due to the potential inception of flow instabilities, which result in worse cooling performance. However, the substantial latent heat of liquid evaporation presents a compelling source in power electronics cooling when temporary overcurrent is needed. In this study, we utilise water evaporation to enhance the cooling performance under temporary module overcurrent conditions, while the water remains in its liquid phase during nominal operation. The proof-of-concept is demonstrated for a Si IGBT/diode half-bridge module cooled with a microchannel array integrated below the direct bonded copper ceramic. The microchannel cooling solution is evaluated in terms of reduction in the junction-to-case thermal resistance and of an increase in the temporary overcurrent capability. The thermal resistance is extracted for different flow rates using Simcenter Micred Power Tester. Infrared and visible spectrum cameras are used to simultaneously record the junction temperature and the evaporating flow in the microchannel array. Flow regimes with parts of individual channels occupied by the flow of vapor have been observed in the overcurrent duration, resulting in heat transported downstream from the chip location, where liquid evaporates, to the outlet of the manifold. Results indicate that evaporation enhances the cooling performance for the tested conditions, with no signs of boiling crisis in the microchannel flow.Keywords
This publication has 33 references indexed in Scilit:
- Fundamentals of Heat Transfer2023
- Two-phase flow boiling instabilities: A reviewAnnals of Nuclear Energy, 2022
- Design, integration and performance analysis of a lid-integral microchannel cooling module for high-power chipApplied Thermal Engineering, 2021
- Enhanced flow boiling in microchannels using auxiliary channels and multiple micronozzles (I): Characterizations of flow boiling heat transferInternational Journal of Heat and Mass Transfer, 2018
- Multiphase fluid flow and heat transfer characteristics in microchannelsChemical Engineering Science, 2017
- Flow boiling in microchannels: Fundamentals and applicationsApplied Thermal Engineering, 2017
- Next Generation Microchannel Heat Exchangers2013
- Macro-to-microchannel transition in two-phase flow: Part 1 – Two-phase flow patterns and film thickness measurementsExperimental Thermal and Fluid Science, 2011
- Critical heat flux for subcooled flow boiling in micro-channel heat sinksInternational Journal of Heat and Mass Transfer, 2009
- Effects of inlet/outlet configurations on flow boiling instability in parallel microchannelsInternational Journal of Heat and Mass Transfer, 2008