Optimal design of an aircraft-skin-integrated micro-pin-fin condenser for the water-enhanced turbofan
Authors:
- Tao WangTWTao Wang
- Feng ZhangFZFeng Zhang
- Peng RenPRPeng Ren
- Zhao YinZYZhao Yin
- Xiangjun FangXFXiangjun Fang
Preprint
- 24 October 2026
- preprint
- Published by Elsevier in SSRN Electronic Journal
Abstract
The water-enhanced turbofan (WET) is an emerging engine concept with the potential to substantially reduce fuel consumption and emissions. Its condenser is a key component that enables water condensation by cooling the core exhaust to induce condensation. Existing designs are constrained by small heat-transfer temperature differences, high mass and large pressure losses, limiting WET development. This study proposes a novel aircraft-skin-integrated micro-pin-fin condenser, with pin fins and hot-side passages located on the inner side of the aircraft skin. The configuration uses the high-speed freestream at cruise altitude to cool exhaust through the skin. Models for heat transfer and hot-side pressure loss are developed and validated against three-dimensional CFD simulations and experimental data. Aircraft transport efficiency is adopted as the ultimate design objective to balance condenser mass and hot-side pressure loss. Multi-objective optimization uses the elitist non-dominated sorting genetic algorithm II (NSGA-II). Three-dimensional simulations provide the air-side convective heat-transfer coefficient distribution over the aircraft skin. A simplified design adopts identical condenser units and neglects spatial non-uniformity in this coefficient. A subsequent zonal design divides the installation into six regions according to local air-side heat-transfer coefficients and optimizes the unit geometry and zonal flow allocation. The design result achieves a relative water condensation rate of 100.0%. The selected condenser attains a heat flux of 8.044 kW/m² and a heat transfer per unit mass of 13.683 kW/kg, with a maximum hot-side pressure-loss ratio of 1.708% and a total condenser of 302.154 kg per engine.Keywords
This publication has 22 references indexed in Scilit:
- Performance assessment of the Water Enhanced Turbofan engineAerospace Science and Technology, 2026
- Effect of pin fins on heat transfer during condensation in minichannel heat exchangerInternational Journal of Thermofluids, 2024
- Numerical study of vapor condensation and droplet migration on the asymmetrical micropillar arraysInternational Communications in Heat and Mass Transfer, 2024
- Performance assessment of a multi-fuel hybrid engine for future aircraftAerospace Science and Technology, 2018
- Thermodynamic investigation of parameters affecting the execution of steam injected cooled gas turbine based combined cycle power plant with vapor absorption inlet air coolingApplied Thermal Engineering, 2017
- Numerical simulation of ice accretions on an aircraft wingAerospace Science and Technology, 2012
- Performance characteristics of modified gas turbine cycles with steam injection after combustion exitInternational Journal of Energy Research, 2011
- Forced convective heat transfer across a pin fin micro heat sinkInternational Journal of Heat and Mass Transfer, 2005
- Development of a plate-pin fin heat sink and its performance comparisons with a plate fin heat sinkApplied Thermal Engineering, 2005
- A theoretical basis for the Lockhart-Martinelli correlation for two-phase flowInternational Journal of Heat and Mass Transfer, 1967