Simulation and Measurement of Refractive Index Variation in Localized Rapid Heating Molding for Polymer Optics
- 3 November 2017
- journal article
- research article
- Published by ASME International in Journal of Manufacturing Science and Engineering
- Vol. 140 (1)
Abstract
Localized rapid heating process utilizing carbide-bonded graphene-coated silicon molds is a high-efficiency and energy-saving technique for high-volume fabrication of polymer optics. The graphene coating is used as a rapid heating element because of its high thermal conductivity and low electrical resistivity. However, the optical property of molded polymer and its dependence on process conditions such as heat transfer have not been thoroughly investigated. In this research, finite element method (FEM) simulation was utilized to interpret temperature changes of the graphene coating and heat transfer between graphene and polymethylmethacrylate (PMMA) in localized rapid heating. Experiments were then carried out under different voltages to validate the numerical model. In addition, refractive index variation of the PMMA lens resulting from nonuniform thermal history in molding was demonstrated by simulation modeling as well. Finally, wavefront variation of a PMMA lens molded by localized rapid heating was first studied using an FEM model and then verified by optical measurements with a Shack–Hartmann wavefront sensor (SHWFS). The wavefront variation in a PMMA lens molded by conventional method was also measured. Compared with conventional molding process, localized rapid heating is shown to be a possible alternative for better optical performance with a much shorter cycle time.Keywords
This publication has 21 references indexed in Scilit:
- Atomic Carbide Bonding Leading to Superior Graphene NetworksAdvanced Materials, 2013
- Investigation on the viscoelasticity of optical glass in ultraprecision lens molding processJournal of Materials Processing Technology, 2009
- Compression Molding of Aspherical Glass Lenses–A Combined Experimental and Numerical AnalysisJournal of the American Ceramic Society, 2005
- Numerical Modeling of Viscoelastic Stress Relaxation During Glass Lens Forming ProcessJournal of the American Ceramic Society, 2005
- Review on micro molding of thermoplastic polymersJournal of Micromechanics and Microengineering, 2003
- Fabrication of plastic microchips by hot embossingLab on a Chip, 2002
- Nanoreplication in polymers using hot embossing and injection moldingMicroelectronic Engineering, 2000
- Prediction of shrinkage and warpage in consideration of residual stress in integrated simulation of injection moldingComposite Structures, 1999
- Hot embossing - The molding technique for plastic microstructuresMicrosystem Technologies, 1998
- Relation Between Refractive Index and Density of a Glass at Constant TemperatureJournal of the American Ceramic Society, 1955