JYJianfeng Yu

Jianfeng Yu

*This is an algorithmically generated author record based on publicly available information.

Jianfeng Yu has a total of 8 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Fabrication of Plano-Concave Plastic Lens by Novel Injection Molding Using Carbide-Bonded Graphene-Coated Silica Molds

    by Xiaohua Liu, Lin Zhang, Wenchen Zhou, Tianfeng Zhou, Jianfeng Yu, L. James Lee, Allen Y. Yi

    Injection molding of plastic optical lenses prevails over many other techniques in both efficiency and cost; however, polymer shrinkage during cooling, high level of uneven residual stresses, and refractive index variations have limited its potential use for high precision lens fabrication. In this research, we adopted a newly developed strong graphene network to both plano and convex fused silica mold surfaces and proposed a novel injection molding with graphene-coated fused silica molds. This advanced injection molding process was implemented in the molding of polymer-based plano-concave lenses resulting in reduced polymer shrinkage. In addition, internal residual stresses and refractive index variations were also analyzed and discussed in detail. Meanwhile, as a comparison of conventional injection mold material, aluminum mold inserts with the same shape and size were also diamond machined and then employed to mold the same plano-concave lenses. Finally, a simulation model using moldex3d was utilized to interpret stress distributions of both graphene and aluminum molds and then validated by experiments. The comparison between graphene-coated mold and aluminum mold reveals that the novel injection molding with carbide-bonded graphene-coated fused silica mold inserts is capable of molding high-quality optical lenses with much less shrinkage and residual stresses with a more uniform refractive index distribution.


  • Simulation and Measurement of Refractive Index Variation in Localized Rapid Heating Molding for Polymer Optics

    by Xiaohua Liu, Tianfeng Zhou, Lin Zhang, Wenchen Zhou, Jianfeng Yu, L. James Lee, Allen Y. Yi, James Ly Lee

    Localized rapid heating process utilizing carbide-bonded graphene-coated silicon molds is a high-efficiency and energy-saving technique for high-volume fabrication of polymer optics. The graphene coating is used as a rapid heating element because of its high thermal conductivity and low electrical resistivity. However, the optical property of molded polymer and its dependence on process conditions such as heat transfer have not been thoroughly investigated. In this research, finite element method (FEM) simulation was utilized to interpret temperature changes of the graphene coating and heat transfer between graphene and polymethylmethacrylate (PMMA) in localized rapid heating. Experiments were then carried out under different voltages to validate the numerical model. In addition, refractive index variation of the PMMA lens resulting from nonuniform thermal history in molding was demonstrated by simulation modeling as well. Finally, wavefront variation of a PMMA lens molded by localized rapid heating was first studied using an FEM model and then verified by optical measurements with a Shack–Hartmann wavefront sensor (SHWFS). The wavefront variation in a PMMA lens molded by conventional method was also measured. Compared with conventional molding process, localized rapid heating is shown to be a possible alternative for better optical performance with a much shorter cycle time.