Thermo-Chemical Modeling and Experimental Validation of Pultruded Glass Fiber Reinforced Composites
Open Access
- 14 April 2026
- journal article
- Published by Trans Tech Publications, Ltd. in Solid State Phenomena
- Vol. 387, 61-73
Abstract
This work develops and validates thermo-chemical models for pultrusion of glass fiber–reinforced polyurethane composites on an industrial PulFlex production line. A reduced one-dimensional model combining a calibrated Kamal–Sourour (KS) cure law with an Arrhenius type chemo-rheological viscosity formulation is cross-validated against a three-dimensional ANSYS Composite Cure Simulation using identical material inputs along a three-zone, 0.9144 m heated die. Embedded thermocouples provide in-die temperature histories at 50.8 cm·min⁻¹ for calibration, while additional differential scanning calorimetry (DSC) measurements supply degree of cure (DoC) profiles for independent validation. At the industrial operating speed of 50.8 cm·min⁻¹, the mathematical and ANSYS models both reproduce the measured temperature peak location and exit temperature within a few degrees Celsius and predict a die-exit DoC of approximately 0.95, confirming near-complete curing. Using these calibrated fields as inputs to an analytical pulling-resistance formulation, both models predict comparable pulling force magnitudes and plateau behavior, demonstrating that the simplified 1D framework can capture not only thermo-chemical evolution but also process resistance trends over a range of pulling speeds. The validated 1D model therefore enables efficient exploration of speed–temperature–force tradeoffs for process window design, while the 3D ANSYS model provides a higher-fidelity reference for local gradients and future thermo–chemo–mechanical extensions.Keywords
This publication has 19 references indexed in Scilit:
- Recent and future developments in pultrusion technology with consideration for curved geometries: A reviewComposites Part B: Engineering, 2024
- An assessment on effect of process parameters on pull force during pultrusionThe International Journal of Advanced Manufacturing Technology, 2022
- Sensors for process and structural health monitoring of aerospace composites: A reviewEngineering Structures, 2021
- Digital twin of composite assembly manufacturing processInternational Journal of Production Research, 2020
- Numerical modeling of the mechanics of pultrusion2020
- Mathematical simulation of pultrusion processes: A reviewComposite Structures, 2018
- Material characterization of a polyester resin system for the pultrusion processComposites Part B: Engineering, 2014
- Cure kinetics and viscosity modelling of a high-performance epoxy resin filmPolymer Testing, 2013
- Simulation of heat transfer and cure in pultrusion with a general-purpose finite element packageComposites Science and Technology, 2000
- A numerical model of the viscosity of an epoxy prepreg resin systemPolymer Composites, 1999