Experimental study on tribological behavior of aluminum–copper functionally graded material
- 3 January 2023
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part L: Journal of Materials: Design and Applications
- Vol. 237 (7) , 1592-1602
Abstract
A five-layered aluminum–copper metal functionally graded material was developed through powder metallurgy process. The sample comprises different weight percentages of copper and aluminum that vary from 0 wt% to 100 wt % along the thickness direction. Erosion wear was performed on air jet erosion testing apparatus at a constant impact angle of 90 o and impact velocity of 151 m/s. It was observed that erosion wear decreases when there is an increase in copper content. Layer 1 comprising 100 wt% of copper has shown 76.92% lower wear compared to layer 5 (100 wt% of aluminum). Besides, erosion resistance was enhanced at graded layers due to the formation of Al 2 Cu phase during sintering. Abrasive wear of metal functionally graded material was evaluated on the pin-on-disc test apparatus. Experiments were conducted at different loading conditions on various abrasive surfaces (P120, P800, and P2000). Irrespective of abrasive surface, the specific wear rate of aluminum–copper metal functionally graded material sample increased with an increase in load from 5N to 15N. At 5N, abrasive wear of metal functionally graded material on P2000 grit surface was 87.7% and 27.19% lower compared to P120 and P800, respectively. Eroded and worn-out surfaces were examined microscopically to understand the wear mechanisms and are discussed in detail.Keywords
This publication has 36 references indexed in Scilit:
- Functionally graded materials: A review of fabrication and propertiesApplied Materials Today, 2016
- Development of functionally graded aluminium composites using centrifugal casting and influence of reinforcements on mechanical and wear propertiesTransactions of Nonferrous Metals Society of China, 2016
- Slurry erosion characteristics and erosion mechanisms of stainless steelTribology International, 2014
- Characterization of Oxide Growth on Surface of Al-Mg-Si Welded JointAdvances in Materials Science and Engineering, 2014
- Fabrication and Properties of Al/Al-Cu Functionally Graded MaterialMaterials Science Forum, 2011
- Two‐body abrasive wear behavior of particulate filled polyamide66/polypropylene nanocompositesJournal of Applied Polymer Science, 2010
- A Novel Fabrication Method for Functionally Graded Materials under Centrifugal Force: The Centrifugal Mixed-Powder MethodMaterials, 2009
- Microstructure and properties of hard and wear resistant MMC coatings deposited by laser claddingInternational Journal of Refractory Metals and Hard Materials, 2009
- Characterization of laser powder deposited Ti–TiC composites and functional gradient materialsJournal of Materials Processing Technology, 2008
- Abrasive wear of aluminium composites—a reviewWear, 1996