Experimental characterization and numerical analysis of 3D woven preforms torsional deformation
Authors:
- 9 October 2024
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 46 (3) , 2484-2501
Abstract
To clarify the torsional deformation performance of 3D angle‐interlock woven preforms, this paper aims to establish the relationship between the structural parameters and the torsional deformation performance of fabrics, examining the torsional deformation mechanism of fabrics. The torsional deformation properties of 3D angle‐interlock fabrics are first characterized by experimental methods, and the influence laws of typical structural parameters on the torsional deformation properties of fabrics are obtained. In continuing, a numerical model for 3D angle‐interlock fabric torsional deformation is established based on virtual fiber modeling technology. To demonstrate the accurateness of the newly developed model, its results are methodically compared with the macro‐ and micro‐morphology of fabric torsional deformation, and a reasonably good agreement between their results is attained. The characteristics of the “arc” and “diagonal” arrangement of yarns in the same column after torsional deformation are effectively employed to propose a quantitative analysis of the deviation degree of yarns. This analysis is essentially based on the variation coefficient index, which is commonly utilized to compare and analyze the variation laws of warp and weft cross‐sections at different torsion angles. This study holds scientific significance and engineering value for optimizing the design and enhancing the performance of composite blades.Highlights: Design the torsional deformation device of the preform. The torsion Angle torque curve of the preform was tested. The numerical simulation method of torsion deformation is established. The microstructure deformation mechanism of the preform was analyzed.Keywords
Funding Information
- National Key Research and Development Program of China (2023YFB3709800)
This publication has 51 references indexed in Scilit:
- An integrated preforming-performance model for high-fidelity performance analysis of cured woven composite part with non-orthogonal yarn anglesChinese Journal of Aeronautics, 2022
- In‐plane shear behaviors of unbalanced 3D interlock woven reinforcement in bias extension test: Experiments and finite element modelingPolymer Composites, 2021
- Fatigue behavior and failure mechanisms of 3D angle-interlock woven composite at room and cryogenic temperatures under bendingComposites Communications, 2021
- Effect of reinforcement architecture on the macroscopic mechanical properties of fiberous polymer composites: A reviewPolymer Composites, 2020
- Influence of specimen pre-shear and wrinkling on the accuracy of uniaxial bias extension test resultsComposites Part A: Applied Science and Manufacturing, 2017
- Experimental measurement of wrinkle formation during draping of non-crimp fabricComposites Part A: Applied Science and Manufacturing, 2016
- An elaboration on the shear characterization of dry woven fabrics using trellising testsPolymer Composites, 2013
- Characterising the shear–tension coupling and wrinkling behaviour of woven engineering fabricsComposites Part A: Applied Science and Manufacturing, 2012
- Experimental and numerical analyses of textile reinforcement forming of a tetrahedral shapeComposites Part A: Applied Science and Manufacturing, 2011
- Characterization of mechanical behavior of woven fabrics: Experimental methods and benchmark resultsComposites Part A: Applied Science and Manufacturing, 2008