Experimental and numerical investigations on the mean stress effect on the fatigue of thin-walled tubular joints
Open Access
- 26 January 2026
- journal article
- research article
- Published by Springer Nature in Welding in the World
- Vol. 70 (5) , 1811-1829
Abstract
Welded hollow section joints play a key role in lightweight automotive design, particularly in applications involving buses, trucks, and special-purpose vehicles. High-strength steels enable significant efficiency gains, especially when used in thin-walled constructions that fully exploit their load-bearing potential. In such applications, rectangular hollow section joints with a chord to brace ratio of 1 are widely used and exhibit favorable fatigue performance. However, accurately assessing the fatigue strength of these joints remains a challenge, particularly due to mean stress effects arising from service loads and welding-induced residual stresses. Current design codes address these effects inconsistently: the nominal stress approach often neglects them or provides conservative estimates, while the structural stress concept defined in ISO 14347 is not suitable for wall thicknesses below 4 mm. The effective notch stress approach, although more refined, assumes R-ratio-independent behavior for non-stress-relieved joints and does not differentiate between steel grades. To address these limitations, fatigue tests were conducted within the FOSTA P1603 research project at Munich University of Applied Sciences on X-joints under varying load ratios. The results were supplemented with numerical analyses to refine the assessment methods used in the nominal and the effective notch stress approach. This study contributes to a more accurate fatigue evaluation of thin-walled, high-strength steel joints and aims to extend the applicability of current design guidelines.Keywords
Funding Information
- Forschungsvereinigung Stahlanwendung (P1603)
- Hochschule für angewandte Wissenschaften München
This publication has 19 references indexed in Scilit:
- Sequence effects on the life estimation of welded tubular structures made of S355J2H under uniaxial fatigue loadingWelding in the World, 2024
- Recommendations for Fatigue Design of Welded Joints and Components2024
- Sequence effects on the life estimation of thin-walled welded tubular structures made of HSS + UHSS under bendingWelding in the World, 2022
- An enhancement of the current design concepts for the improved consideration of residual stresses in fatigue-loaded weldsWelding in the World, 2021
- Fatigue life prediction of 316L stainless steel weld joint including the role of residual stress and its evolution: Experimental and modellingInternational Journal of Fatigue, 2021
- Mean stress correction in fatigue design under consideration of welding residual stressWelding in the World, 2020
- Effective notch stress approach for welds having low stress concentrationInternational Journal of Pressure Vessels and Piping, 2016
- Hochfeste nahtlose Rohre und Stahlbauhohlprofile für Krane und den MaschinenbauStahlbau, 2015
- Ermüdungsfestigkeit2007
- Betriebsfestigkeit2006