SKSascha Knefelkamp

Sascha Knefelkamp

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Sascha Knefelkamp has a total of 4 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Influence of mean stress on the fatigue of welded tubular structures under uniaxial fatigue loading

    by Maximilian Kling, Matthias Winkler, Sascha Knefelkamp, Andre Dürr, Klemens Rother

    Welded hollow section joints are essential for weight reduction in load-bearing structures of agricultural machinery and cranes while maintaining high load capacity. In mobile and gantry cranes, their favorable structural properties enhance durability and significantly reduce overall weight, thereby improving maneuverability and energy efficiency. In these applications, primary loads induce cyclic stresses with either tensile or compressive mean components, which interact with residual stresses from the welding process. In the nominal stress approach of existing codes and guidelines, mean stress effects are typically disregarded due to the assumption of high residual tensile stresses. The structural stress method outlined in the CIDECT Design Guide also does not account for residual or mean stresses, nor does it differentiate between material grades. In contrast, the effective notch stress concept considers mean stress effects via enhancement factors but assumes stress ratio independence for non-stress-relieved and complex welded structures. To address these limitations, fatigue tests with wall thicknesses below 10 mm were conducted within the FOSTA P 1603 research project at Munich University of Applied Sciences. The tests focused on X-joints made of rectangular and circular hollow section tubes using S355J2H and high-strength S620QH steels. The joints were tested under up to four different load ratios. The results are evaluated using the nominal stress and local stress fatigue approaches to identify discrepancies in current guidelines and to develop more accurate, less conservative recommendations. This paper presents the experimental findings and highlights the need for improved fatigue assessment methods for welded hollow section joints.

  • Open Access

    Experimental and numerical investigations on the mean stress effect on the fatigue of thin-walled tubular joints

    by Maximilian Kling, Matthias Winkler, Sascha Knefelkamp, Andre Dürr, Klemens Rother

    Welded hollow section joints play a key role in lightweight automotive design, particularly in applications involving buses, trucks, and special-purpose vehicles. High-strength steels enable significant efficiency gains, especially when used in thin-walled constructions that fully exploit their load-bearing potential. In such applications, rectangular hollow section joints with a chord to brace ratio of 1 are widely used and exhibit favorable fatigue performance. However, accurately assessing the fatigue strength of these joints remains a challenge, particularly due to mean stress effects arising from service loads and welding-induced residual stresses. Current design codes address these effects inconsistently: the nominal stress approach often neglects them or provides conservative estimates, while the structural stress concept defined in ISO 14347 is not suitable for wall thicknesses below 4 mm. The effective notch stress approach, although more refined, assumes R-ratio-independent behavior for non-stress-relieved joints and does not differentiate between steel grades. To address these limitations, fatigue tests were conducted within the FOSTA P1603 research project at Munich University of Applied Sciences on X-joints under varying load ratios. The results were supplemented with numerical analyses to refine the assessment methods used in the nominal and the effective notch stress approach. This study contributes to a more accurate fatigue evaluation of thin-walled, high-strength steel joints and aims to extend the applicability of current design guidelines.