Bending strength and notched-sample fatigue life of hBN/TiC-reinforced steel 316 L: A numerical and experimental analysis
- 23 September 2019
- journal article
- research article
- Published by SAGE Publications in Journal of Composite Materials
- Vol. 54 (8) , 1001-1011
Abstract
Mechanical failure under cyclic and dynamic loading has always been a concern in engineering applications. Many different properties can be achieved by adding different materials to the metal matrix nanocomposites. In this study, steel 316 L is selected as the matrix, and the additive materials of titanium carbide and hexagonal boron nitride in 3.5 wt% for each one are added as the reinforcement particles. The samples are fabricated by powder metallurgy, compacted in pressure of 410 MPa, and sintered in temperature of 1375℃ for 4 h. In addition, some pure steel 316 L samples were provided for comparison purposes. Numerical simulation of bending strength and fatigue life of the notched samples were conducted and verified with experimental tests on the mechanical parts. It appeared that the nanocomposite specimens present a higher mechanical reliability relative to the pure 316 L as a result of adding nanoparticles. Steel 316 L S–N curves of the notched samples are also obtained from numerical analysis.Keywords
This publication has 20 references indexed in Scilit:
- The effects of TiC grain size and steel binder content on the reciprocating wear behaviour of TiC-316L stainless steel cermetsWear, 2016
- Characterization of microstructure and tensile fracture behavior in a novel infiltrated TiC–steel compositeScripta Materialia, 2016
- Mechanically alloyed nanocompositesProgress in Materials Science, 2013
- Fabrication of in situ TiC locally reinforced manganese steel matrix composite via combustion synthesis during castingMaterials & Design (1980-2015), 2013
- Tribological characteristics of Si3N4–hBN ceramic materials sliding against stainless steel without lubricationWear, 2010
- On structure and mechanical properties of ultrasonically cast Al–2% Al2O3 nanocompositeMaterials Research Bulletin, 2009
- Mechanical and tribological properties of hot-pressed h-BN/Si3N4 ceramic compositesCeramics International, 2006
- BN/Si3N4 nanocomposite with high strength and good machinabilityMaterials Science and Engineering: A, 2006
- A Review on the various synthesis routes of TiC reinforced ferrous based compositesJournal of Materials Science, 2002
- Processing of discontinuously-reinforced metal matrix composites by rapid solidificationProgress in Materials Science, 1995