The effect of sintering time on the tribological properties of automotive brake pads
Open Access
- 30 March 2023
- journal article
- research article
- Published by International Journal of Automotive Engineering and Technologies in International Journal of Automotive Engineering and Technologies
- Vol. 12 (1) , 16-21
Abstract
In this study, the effect of sintering temperature on the physical, chemical and tribological effects of sintered automotive friction materials was investigated. Using the powder metallurgy method, 3 different samples were produced with the codes A1, A6 and A11. Mixing, pressing and sintering processes were applied respectively as production steps. Mixing time is 90 minutes, speed is 15 rpm. The pressing pressure is 250 MPa and the duration is 1 min. The sintering temperature was 800 °C and the sintering time was 1, 6 and 11 hours, respectively. The sintering process was carried out in the sintering mold using Argon gas. As the sintering time increased, it was observed that there was an increase in the time-dependent friction coefficients of the samples. Increasing the sintering time also increased the density of the samples. As the sintering time increased, the gap in the sample decreased, as it provided better bonding of the dustsers.Keywords
This publication has 12 references indexed in Scilit:
- A pin-on-disc study on the dry sliding behavior of a Cu-free friction material containing different types of natural graphiteWear, 2020
- Friction material composite: types of brake friction material formulations and effects of various ingredients on brake performance–a reviewMaterials Research Express, 2019
- Thermo-mechanical performance of automotive disc brakesMaterials Today: Proceedings, 2018
- Review on the friction and wear of brake materialsAdvances in Mechanical Engineering, 2016
- Friction materials2016
- Friction Material Composites2015
- Effect of Sintering Time on the Density, Porosity Content and Microstructure of Copper – 1 wt. % Silicon Carbide CompositesAdvanced Materials Research, 2014
- COUPLED STRUCTUAL / THERMAL ANALYSIS OF DISC BRAKEInternational Journal of Research in Engineering and Technology, 2012
- A pin-on-disc simulation of airborne wear particles from disc brakesWear, 2010
- The effect of Al2O3 on the friction performance of automotive brake friction materialsTribology International, 2007