Effect of Plasma Actuator Layout on the Passage Vortex Reduction in a Linear Turbine Cascade for a Wide Range of Reynolds Numbers
Open Access
Abstract
This study examined how various plasma actuator (PA) configurations affect the passage vortex (PV) reduction in a linear turbine cascade (LTC) utilizing dielectric barrier discharge PAs. The experiments were carried out under three specific layout conditions: axial placement of the PA, slanted placement at the blade inlet, and slanted placement inside the blade. Particle image velocimetry was employed to measure the velocity distribution of the secondary flow at the LTC exit, followed by an analysis of the streamline patterns, turbulence intensity distribution, and vorticity distribution. At a Reynolds number of 3.7 × 104, the PA with an oblique orientation at the blade inlet provided the most effective PV suppression. The average value of the secondary flow velocity and the peak vorticity value at the LTC exit decreased by 59.0% and 68.8%, respectively, compared to the no-control case. Furthermore, the wind tunnel blower’s rotation speed was modified, adjustments were made to the LTC’s mainstream velocity, and the Reynolds number transitioned from 1.0 × 104 to 9.9 × 104, approximately 10 times. When the slanted PA was used at the blade inlet, the PV suppression effect was the highest. The peak vorticity value owing to the PV at the LTC exit decreased by 62.9% at the lowest Reynolds number of 1.0 × 104. The Reynolds number increased with a higher mainstream velocity and decreased flow induced by the PA, consequently reducing the PV suppression effect. However, the drive of the PA was effective even under the most severe conditions (9.9 × 104), and the peak vorticity value was reduced by 20.2%.Keywords
Funding Information
- Japan Society for the Promotion of Science (21K03868)
This publication has 43 references indexed in Scilit:
- Parametric Optimization of Unsteady End Wall Blowing on a Highly Loaded Low-Pressure TurbineJournal of Turbomachinery, 2014
- A Global Approach to Turbomachinery Flow Control: Passage Vortex ControlJournal of Turbomachinery, 2013
- Secondary Flow Loss Reduction Through Blowing for a High-Lift Front-Loaded Low Pressure Turbine CascadeJournal of Turbomachinery, 2012
- Pressure Dependence of Dielectric Barrier Discharge Plasma Flow ActuatorsAIAA Journal, 2012
- Secondary Flow Loss Reduction in a Turbine Cascade with a Linearly Varied Height Streamwise Endwall FenceInternational Journal of Rotating Machinery, 2011
- Dielectric Barrier Discharge Plasma Actuators for Flow ControlAnnual Review of Fluid Mechanics, 2010
- Electric wind produced by a surface dielectric barrier discharge operating in air at different pressures: aeronautical control insightsJournal of Physics D: Applied Physics, 2008
- Unsteady Flow Field of an Axial-Flow Turbine Rotor at a Low Reynolds NumberJournal of Turbomachinery, 2006
- The 1993 IGTI Scholar Lecture: Loss Mechanisms in TurbomachinesJournal of Turbomachinery, 1993
- Recent Progress in the Understanding of Basic Aspects of Secondary Flows in Turbine Blade PassagesJournal of Engineering for Gas Turbines and Power, 1985