On Combined Tensile-Shear Performance of Laser-Welded Dissimilar Overlap Joints Made of Austenitic Stainless Steel and Low-Carbon Steel
Open Access
- 27 October 2025
- journal article
- research article
- Published by MDPI AG in Journal of Manufacturing and Materials Processing
- Vol. 9 (11) , 351
Abstract
This paper addresses the mechanical characterization of dissimilar overlap joints made by autogenous laser welding between thin sheets of low-carbon steel (CS) and austenitic stainless steel (SS) with an optimized welding technology able to produce sound overlap joints. This involved applying the laser beam from the CS-side to reduce the SS overheating. The research is focused on the analysis of combined tensile-shear behavior of the weld and of the heat-affected zones. During testing, the applied tensile-shear load rotates the weld connecting the CS and SS plates. The rotation angle transmitted to the free ends of the plates, together with relevant strain fields, were measured by using a digital image correlation system, VIC-2D. Thus, it was found that the weld acts as a non-linear hinge which experiences a sudden loss of stiffness when strain concentrations develop from the weld ligament edges towards the loaded sides of the plates. The welded joint fails by yielding localization and necking in the CS plate, far from the weld. This mode of failure is a consequence of the weld and heat-affected zone strength mismatches of 1.09 and 1.33, respectively. These values are consistent with the hardness profile and the documented microstructural heterogeneities.Keywords
This publication has 36 references indexed in Scilit:
- Microstructure and Micromechanical Properties of Delta Ferrite Morphologies in Wire Arc Additive Manufacturing 316LSi Austenitic Stainless SteelMetallography, Microstructure, and Analysis, 2025
- Advancements in Laser Beam Welding for Dissimilar Material Joining: Exploring Weldability Assessment, Challenges, Parametric Influences on the Mechanical–Microstructural Properties in Steel‐Alloyed Metal CombinationsSteel Research International, 2024
- Improvement of electrical and mechanical properties of laser welded lap joints via dimensional optimizationThe International Journal of Advanced Manufacturing Technology, 2023
- Analysis and prevention of weld crater cracking in circumferential laser microwelding of automotive pressure sensorsEngineering Failure Analysis, 2021
- Damage tolerance of the prestressing steel in a bridge stay-cable after thirty years of service in a graded, extremely adverse environmentConstruction and Building Materials, 2021
- New testing method for assessing the cracking sensibility of stressed tendon rods in aggressive environmentsEngineering Failure Analysis, 2016
- Failure characterization of laser welds under combined loading conditionsInternational Journal of Mechanical Sciences, 2013
- Specific properties of ferritic/austenitic Dissimilar Metals Welded JointsWelding in the World, 2011
- Modeling of failure mode of laser welds in lap-shear specimens of HSLA steel sheetsEngineering Fracture Mechanics, 2011
- Ferritic-austenitic solidification mode in austenitic stainless steel weldsMetallurgical Transactions A, 1980