Study on Strength Optimization of CFRP Single-Lap Joints Based on Local Pre-Curing Effect
- 12 December 2025
- journal article
- Published by Trans Tech Publications, Ltd. in Key Engineering Materials
- Vol. 1036, 115-125
Abstract
The early failure of single-lap adhesive joints in carbon fiber reinforced polymer (CFRP) composites is typically induced by stress concentration at the edges of the overlap region. To address this issue, this study proposes a novel local pre-curing process system based on gradient thermal curing regulation. Through multi-physical field modeling of the temperature-curing coupling effect and a gradient curing control strategy, active optimization of the adhesive layer stress distribution is achieved. By optimizing the interface stress distribution, the proposed technique demonstrates the potential to enhance the overall joint performance by 3-6%. This research combines Abaqus finite element simulation and experimental verification. A CFRP single-lap joint model considering the temperature-curing coupling effect was established to analyze the influence of local pre-curing on the stress distribution of the adhesive layer. The results show that: 1. Local pre-curing can reduce the peel stress in the critical edge danger zone by about 3 - 5% while improving the shear strength in the middle region. 2. The preferential curing at the center of the adhesive layer can induce stress redistribution, relieve the stress concentration at the edges, and thus improve the overall load-bearing capacity of the joint. This study provides a low-cost and easily implementable solution for optimizing the performance of CFRP joints, showing potential applications in the field of lightweight aerospace structures. Through the synergistic effect of precise thermal management and regulation of the adhesive's rheological properties, it offers new insights for advanced composite joining technologies.Keywords
This publication has 19 references indexed in Scilit:
- Ultrafine CoNi alloy nanoparticles anchored on surface-roughened halloysite nanotubes for highly efficient catalytic hydrogenation of 4-nitrophenolChemical Engineering Journal, 2024
- Force analysis and distribution evolution of Fe3O4 nanoparticles in magnetic fluidsChinese Journal of Physics, 2024
- Progress in Degradation of Volatile Organic Compounds by Catalytic Oxidation: a Review Based on the Kinds of Active Components of CatalystsWater, Air, & Soil Pollution, 2023
- Numerical and experimental investigation on the load‐bearing performance of plain‐woven composites hybrid bonded‐bolted jointsPolymer Composites, 2023
- Impact damage assessment in patch‐repaired carbon fiber‐reinforced polymer laminates using the nonlinear Lamb wave‐mixing techniquePolymer Composites, 2022
- Intensity of singular stress fields (ISSFs) in micro-bond test in comparison with ISSFs in pull-out testInternational Journal of Mechanical Sciences, 2020
- Electrophilic chlorination of dibenzo-p-dioxin and dibenzofuran over composite copper and iron chlorides and oxides in combustion flue gasChemosphere, 2020
- Single-fiber pull-out analysis comparing the intensities of singular stress fields (ISSFs) at fiber end/entry pointsInternational Journal of Mechanical Sciences, 2020
- 3D explicit finite element analysis of tensile failure behavior in adhesive-bonded composite single-lap jointsComposite Structures, 2018
- Strength prediction of single- and double-lap joints by standard and extended finite element modellingInternational Journal of Adhesion and Adhesives, 2011