CFD investigation on thermal–hydraulic performance of flow boiling within micro‐pillar array surfaces
- 19 February 2026
- journal article
- Published by Wiley in The Canadian Journal of Chemical Engineering
- Vol. 104 (9) , 5121-5132
Abstract
Micro‐structured surfaces are widely applied to enhance surface wettability and reduce hydraulic resistance. The study employs computational fluid dynamics (CFD) theory to investigate the flow boiling heat transfer performance of micro‐pillar array surfaces. A three‐dimensional dual‐channel model with micro‐pillar arrayed surface is developed. The volume of fluid (VOF) model is utilized to capture the two‐phase flow behaviour, and the mass transfer process is calculated by the Lee model. R134a is used as a working fluid undergoing phase transition. The effects of micro‐pillar height, diameter, and degree of subcooling are investigated. Parametric analyses revealed that the performance evaluation criterion (PEC) decreased by 18% and 47.9% with increasing pillar height (1–4 mm) and diameter (1–6 mm), respectively, due to flow stagnation and elevated friction losses. The performance evaluation criterion (PEC) were positively correlated with elevated subcooling levels. The optimal geometry (3 mm height and 1 mm diameter) achieved a 58.6% PEC superiority over traditional herringbone corrugations.Keywords
Funding Information
- Natural Science Foundation of Gansu Province (25JRRA922)
This publication has 27 references indexed in Scilit:
- Experimental investigation of the two-phase local heat transfer coefficients for condensation of R134a in a micro-structured plate heat exchangerHeat and Mass Transfer, 2021
- Flow patterns and pressure drop of downward two-phase flow in a capsule-type plate heat exchangerExperimental Thermal and Fluid Science, 2019
- Comparative evaluation of flow boiling heat transfer characteristics of R-1234ze(E) and R-134a in plate heat exchangers with different Chevron anglesApplied Thermal Engineering, 2018
- Experimental investigation on heat transfer characteristics of plat heat exchanger applied in organic Rankine cycle (ORC)Applied Thermal Engineering, 2017
- Endwall heat transfer and pressure loss measurements in staggered arrays of adiabatic pin finsApplied Thermal Engineering, 2016
- A new model for refrigerant boiling inside Brazed Plate Heat Exchangers (BPHEs)International Journal of Heat and Mass Transfer, 2015
- Analysis and optimization of fan-shaped pin–fin in a rectangular cooling channelInternational Journal of Heat and Mass Transfer, 2014
- Numerical study of heat transfer enhancement by unilateral longitudinal vortex generators inside parabolic trough solar receiversInternational Journal of Heat and Mass Transfer, 2012
- Heat transfer and pressure drop during HFC refrigerant saturated vapour condensation inside a brazed plate heat exchangerInternational Journal of Heat and Mass Transfer, 2010
- Flow boiling of R134a and ammonia in a plate heat exchangerInternational Journal of Heat and Mass Transfer, 2008