Unpacking Intermineral Synergies and Reactions During Dust Deposition in an Impingement Coolant Jet
- 6 December 2022
- journal article
- research article
- Published by Wiley in Journal of Turbomachinery
- Vol. 145 (5) , 1-29
Abstract
This paper seeks to unpack synergies that exist between minerals during deposition of the heterogeneous AFRL02 mixture in gas turbine engines and demonstrate that the contributions of each mineral cannot be considered independently. In each experiment, one gram of mineral dust (0–10 µm particle diameter distribution) was injected into an 894 K, 57 m/s coolant flow impinging normally on a Hastelloy X plate with a surface temperature of 1033 K, 1144 K, or 1255 K. Capture efficiency measurements, deposit morphology analyses, and X-ray diffraction results are reported. Besides AFRL02, single mineral dusts, dual mineral dusts, and AFRL02-like dust blends lacking in one mineral were tested. The results of the experiments elucidate that the deposition behavior of single minerals indeed cannot explain the composite deposition of heterogeneous mixtures. For example, gypsum had the highest capture efficiency of any single mineral in ARFL02, and yet removing gypsum from AFRL02 counterintuitively raised the capture efficiency of that blend when compared to AFRL02. Quartz was found to erode albite deposits but stick to and build upon dolomite and halite deposits, even though quartz did not deposit significantly as a single mineral. Quartz also chemically reacted with gypsum and dolomite to form wollastonite and diopside, respectively. Finally, we found that the capture efficiency of each blend increased with plate temperature, but not according to the same trend. Results are interpreted through the lens of CaO–MgO–Al2O3–SiO2 eutectic chemistry, but the chemical pathways by which these eutectics come into existence is found to be of equal importance.Keywords
This publication has 21 references indexed in Scilit:
- A re-evaluation of the 2010 quantitative understanding of the effects volcanic ash has on gas turbine enginesProceedings of the Institution of Mechanical Engineers, Part G: Journal of Aerospace Engineering, 2016
- Volcanic ash melting under conditions relevant to ash turbine interactionsNature Communications, 2016
- Technology options for large-scale solid-fuel combustion2016
- Decomposition and solid reactions of calcium sulfate doped with SiO2, Fe2O3 and Al2O3Journal of Analytical and Applied Pyrolysis, 2015
- Thermal behavior of natural dolomiteJournal of Thermal Analysis and Calorimetry, 2014
- An overview of the behaviour of biomass during combustion: Part I. Phase-mineral transformations of organic and inorganic matterFuel, 2013
- Operation of Gas Turbine Engines in an Environment Contaminated With Volcanic AshJournal of Turbomachinery, 2012
- Thermochemical Interaction of Thermal Barrier Coatings with Molten CaO–MgO–Al 2 O 3 –SiO 2 (CMAS) DepositsJournal of the American Ceramic Society, 2006
- Jet‐Impingement Heat Transfer in Gas Turbine SystemsAnnals of the New York Academy of Sciences, 2001
- Viscosity of liquid albite, a network materialJournal of Non-Crystalline Solids, 1981