ENEric P. Nied

Eric P. Nied

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Eric P. Nied has a total of 4 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Unpacking Intermineral Synergies and Reactions During Dust Deposition in an Impingement Coolant Jet

    by Eric P. Nied, Jeffrey P. Bons, Ryan K. Lundgreen

    This paper seeks to unpack synergies that exist between minerals during deposition of the heterogeneous AFRL02 mixture in gas turbine engines and demonstrate that the contributions of each mineral cannot be considered independently. In each experiment, one gram of mineral dust (0–10 µm particle diameter distribution) was injected into an 894 K, 57 m/s coolant flow impinging normally on a Hastelloy X plate with a surface temperature of 1033 K, 1144 K, or 1255 K. Capture efficiency measurements, deposit morphology analyses, and X-ray diffraction results are reported. Besides AFRL02, single mineral dusts, dual mineral dusts, and AFRL02-like dust blends lacking in one mineral were tested. The results of the experiments elucidate that the deposition behavior of single minerals indeed cannot explain the composite deposition of heterogeneous mixtures. For example, gypsum had the highest capture efficiency of any single mineral in ARFL02, and yet removing gypsum from AFRL02 counterintuitively raised the capture efficiency of that blend when compared to AFRL02. Quartz was found to erode albite deposits but stick to and build upon dolomite and halite deposits, even though quartz did not deposit significantly as a single mineral. Quartz also chemically reacted with gypsum and dolomite to form wollastonite and diopside, respectively. Finally, we found that the capture efficiency of each blend increased with plate temperature, but not according to the same trend. Results are interpreted through the lens of CaO–MgO–Al2O3–SiO2 eutectic chemistry, but the chemical pathways by which these eutectics come into existence is found to be of equal importance.


  • The Effect of Gas and Surface Temperature on Cold-Side and Hot-Side Turbine Deposition

    by Jeffrey P. Bons, Chihsiu Lo, Eric Nied, Jiaxuan Han

    Deposition studies were conducted using two impingement jet facilities: a 60 m/s cold jet (830–950 K) impinging on a heated Hastelloy-X surface (1033–1255 K) and a 215 m/s hot jet (1450–1625 K) impinging on an uncooled ceramic target or a cooled thermal barrier coated (TBC) surface (1090–1400 K). These can be considered analogs for an internal impingement cooling jet flow and an external nozzle guide vane leading edge flow respectively. Airflows were seeded with 0–10 µm Arizona road dust and deposition accumulated over a period of 5–10 min. Selected tests were completed with other size distributions. Studies were conducted by varying flow temperature at constant surface temperature and vice-versa. For both hot and cold impingement jets, the sensitivity of capture efficiency to fluid (and thus particle) temperature was found to be roughly double the sensitivity to surface temperature. Hot jet tests with three different size distributions of dust (0–5, 0–10, and 5–10 µm) allowed particle size sensitivity to be evaluated. For both target types (ceramic and cooled TBC), the 0–10 µm test dust produced the highest deposition rate of the three size distributions. Possible explanations for the observed behavior are proposed. Companion CFD studies modeling both impinging jets with particle deposition demonstrate that temperature induced variations in particle trajectories alone are not sufficient to explain observed deposition trends with temperature. Implications for the development of a universal sticking model relevant to gas turbine deposition are discussed.