High-Temperature Deformation Behaviors of the C-Doped and N-Doped High Entropy Alloys
Open Access
Abstract
High entropy alloys (HEAs) containing multi-principal metallic constituents have attracted much attention. A good understanding of their hot-deformation behavior and recrystallization mechanism is the prerequisite for microstructures tuning and for optimizing mechanical performance. Here, the flow behavior and recrystallization mechanism of the N-doped and C-doped face-centered cubic phase HEAs are produced at high temperatures by hot-compression at 1123–1273 K, with strain rates of 0.1–0.001 s−1. Constitutive equations were successfully constructed to reveal flow behavior, and stress-strain curves were predicted using strain compensated polynomial functions. Discontinuous and continuous dynamic recrystallization proceeded concurrently when compressed at a low temperature and high strain rate, whereas discontinuous recrystallization, which occurs at primary grain boundaries, became predominant at a high temperature and low strain rate, significantly contributing to the refinement and homogenization of the grains. For this reason, a relatively high temperature and a low strain rate, in which the recrystallized grains exhibit equiaxed morphology and very weak texture, are more suitable for refining grains. The average size of the grains was approximately 10 μm. This study sheds light on grain optimization and mechanical properties through thermomechanical processing.Keywords
Funding Information
- National Natural Science Foundation of China (51674079)
- China Postdoctoral Science Foundation (2016M600211)
- Japan Society for the Promotion of Science (19K14838, 21K03766)
This publication has 47 references indexed in Scilit:
- Linking recovery and recrystallization through triple junction motion in aluminum cold rolled to a large strainActa Materialia, 2013
- Introduction to DislocationsMaterials Today, 2011
- A new relationship between the stress multipliers of Garofalo equation for constitutive analysis of hot deformation in modified 9Cr–1Mo (P91) steelMaterials Science and Engineering: A, 2011
- Effect of temperature and strain rate on the compressive deformation behavior of 42CrMo steelJournal of Materials Processing Technology, 2008
- Influence of stacking fault energy on nanostructure formation under high pressure torsionMaterials Science and Engineering: A, 2005
- Nanostructured High‐Entropy Alloys with Multiple Principal Elements: Novel Alloy Design Concepts and OutcomesAdvanced Engineering Materials, 2004
- Constitutive analysis in hot workingMaterials Science and Engineering: A, 2002
- Evolution of microbands in high purity aluminium–3%magnesium during hot deformation testing in tension–compressionScripta Materialia, 2001
- Microstructure and local crystallographic evolution in an Al1 wt% Mg alloy deformed at intermediate temperature and high strain-rateActa Materialia, 1996
- The Deformation and Ageing of Mild Steel: II Characteristics of the L ders DeformationProceedings of the Physical Society. Section B, 1951