WR-3 Band Waveguide Filter Tolerance Analysis and Surface Metallization Comparison
Open Access
- 22 August 2020
- journal article
- research article
- Published by Springer Nature in Journal of Infrared, Millimeter, and Terahertz Waves
- Vol. 41 (12) , 1576-1590
Abstract
In this paper, a fifth-order WR-3 band waveguide filter with two transmission zeros (TZs) is presented. The design process is described and manufacturing issues are addressed. The filter is designed to fulfill a center frequency of 237.9 GHz and a fractional bandwidth of 2.64%. Three identical filters are manufactured with the classical computerized numerical control (CNC) milling technique in order to obtain information about the manufacturing repeatability for filter structures in the WR-3 band. The comparison shows that even in very high frequency regions a good repeatability can be achieved, if modern high-speed cutting (HSC) CNC milling machines are used. A comprehensive tolerance analysis is accomplished to classify the obtained results. The filters were manufactured from brass to ensure a meaningful comparability and due to the good machining qualities in CNC machines. In order to reduce the losses, the filters are afterwards sputtered with different materials (gold, silver, copper) to evaluate the effect on the insertion loss at very high frequencies. In comparison with the literature, it is shown that even narrow-band filters, which show a high sensitivity to machining tolerances, can be manufactured with high reliability and manufacturing repeatability in modern CNC milling machines. One of the measured filters shows a return loss higher than 20 dB over the whole passband.Keywords
This publication has 17 references indexed in Scilit:
- Benchmarking electrical loss in rectangular metallic waveguide at submillimeter wavelengths2017
- Analysis of 220-GHz Low-Loss Quasi-Elliptic Waveguide Bandpass FilterIEEE Microwave and Wireless Components Letters, 2017
- Micromachined multilayer bandpass filter at 270 GHz using dual-mode circular cavities2017
- WR-3 Band Quasi-Elliptical Waveguide Filters Using Higher Order Mode ResonancesIEEE Transactions on Terahertz Science and Technology, 2017
- SU‐8 micromachined WR‐3 band waveguide bandpass filter with low insertion lossElectronics Letters, 2013
- Low-Loss Elliptical Response Filter at 100 GHzIEEE Microwave and Wireless Components Letters, 2012
- Micromachined WR-3 waveguide filter with embedded bendsElectronics Letters, 2011
- Millimeter Wave Vector Analysis Calibration and Measurement Problems Caused by Common Waveguide Irregularities2000
- Experimental Attenuation of Rectangular Waveguides at Millimeter WavelengthsIEEE Transactions on Microwave Theory and Techniques, 1979
- Excess Conduction Losses at Millimeter WavelengthsIEEE Transactions on Microwave Theory and Techniques, 1976