Thermodynamics and Mechanics of Thermal Spraying of Steel EN 10060 Substrate with NiCrBSi Alloy after Milling
Open Access
- 25 November 2020
- Vol. 13 (23) , 5344
Abstract
The objective of this paper is to present a new way of identifying and predicting the relationship between thermodynamic and physical-mechanical parameters in the formation of a layer after spraying on a substrate with NiCrBSi alloy and its subsequent processing by milling. The milling of the spherical surface of the EN 10060 material after spraying was performed on the DMU 40 eVolinear linear milling centre. The experimental part of the article is focused on investigating the influence of cutting parameters when machining a selected combination of materials (substrate-coating: EN 10060 steel-NiCrBSi alloy). The experiment is based on the results of direct measurements of three basic cutting parameters, namely: cutting speed vc (m∙min−1), feed per tooth fz (mm), and the depth of cut ap (mm). The new distribution functions of selected cutting parameters were derived. The analytical results of the thermodynamic calculations performed on nickel-based alloy can be used for accurate predictions of the technological parameters of milling a spherical substrate made of EN 10060 steel after HVOF spraying, and also for both sample preparation and the subsequent production of high-quality coatings.Keywords
Funding Information
- Ministerstvo Školství, Mládeže a Tělovýchovy (ED2.1.00/19.0391)
This publication has 27 references indexed in Scilit:
- Effects of remelting processes on porosity of NiCrBSi flame sprayed coatingsSurface Engineering, 2016
- High-Entropy Alloys: A Critical ReviewMaterials Research Letters, 2014
- Influence of Tool Materials on Machinability of Titanium- and Nickel-Based Alloys: A ReviewMaterials and Manufacturing Processes, 2014
- Refractory high-entropy alloysIntermetallics, 2010
- From Powders to Thermally Sprayed CoatingsJournal of Thermal Spray Technology, 2009
- Capability of thermodynamic calculation in the development of alloys for deposition of corrosion‐protection coatings via thermal sprayingMaterials and Corrosion, 2007
- Relationships between NiCrBSi particle characteristics and corresponding coating properties using different thermal spraying processesSurface and Coatings Technology, 2005
- MACHINABILITY OF NICKEL-BASED HIGH TEMPERATURE ALLOYSMachining Science and Technology, 2000
- Mechanical properties of HVOF coatingsJournal of Thermal Spray Technology, 1995
- High speed milling of nickel-based superalloysJournal of Materials Processing Technology, 1992