Experimental Investigation of the Effect of Bleed on the Aerodynamics of a Low-Pressure Compressor Stage in a Turbofan Engine
- 14 December 2023
- journal article
- research article
- Published by Wiley in Journal of Turbomachinery
- Vol. 146 (3) , 1-18
Abstract
The compression system in modern turbofan engines is split into stages linked by transition ducts. Downstream of the low-pressure system, a handling bleed is often required and, in conjunction with structural vanes, can introduce component interactions, which compromise aerodynamic performance. In this paper, a fully annular, low-speed test facility incorporating a 1½ stage axial compressor is used to examine the flow in the last stage of a low-pressure compressor and the downstream transition duct. The transition duct incorporated load-bearing struts, including a so-called king strut with twice the thickness of the regular struts. The bleed utilized a 360-deg annular slot located on the casing immediately downstream of the low-pressure rotor and upstream of the outlet guide vane. The results showed that both the regular and king strut caused a similar flow distortion in the vane row but overall imposed a negligible effect on overall performance. The addition of bleed had a larger effect, generating an increasing outboard bias at the rotor exit as the bleed flow migrated toward the offtake. At the design operating point, the outlet guide vanes were relatively insensitive to this until the highest bleed rate (18%) where evidence of stall was observed. At a lower operating point, a modification to the rotor swirl caused additional incidence onto the vanes, resulting in an earlier onset of the stall; a full stall was observed above 10% bleed. Increasing bleed caused a gradual increase in duct loss up to stall when losses increased rapidly.Keywords
This publication has 15 references indexed in Scilit:
- Integrated Outlet Guide Vane Design for an Aggressive S-Shaped Compressor Transition DuctJournal of Turbomachinery, 2012
- Aerodynamic Performance of a Coolant Flow Off-Take Downstream of an Outlet Guide VaneJournal of Turbomachinery, 2012
- Numerical Design and Experimental Evaluation of an Aggressive S-Shaped Compressor Transition Duct With Bleed2011
- The Effect of an Upstream Compressor on a Non-Axisymmetric S-Duct2010
- Optimization of Nonaxisymmetric Endwalls in Compressor S-Shaped DuctsJournal of Turbomachinery, 2009
- Mechanism of the Interaction of a Ramped Bleed Slot With the Primary FlowJournal of Turbomachinery, 2006
- The Effect of Operating Conditions on the Aerodynamic Performance of an Integrated OGV and S-Shaped Duct2001
- Performance Assessment of an Annular S-Shaped DuctJournal of Turbomachinery, 1997
- The Influence of Inlet Swirl on the Flow Within an Annular S-Shaped Duct1996
- Characteristics of combustor diffusersProgress in Aerospace Sciences, 1995