Multiscale failure mechanism of Armox 500T and 600T under complete ballistic perforation: Three-dimensional damage morphology and adiabatic shear band-assisted cracking
Authors:
- Seung-Yong LeeSLSeung-Yong Lee
- Bong-Cheon ParkBPBong-Cheon Park
- Sun-Woong ShinSSSun-Woong Shin
- Yeongsu HaYHYeongsu Ha
- Yongnam KimYKYongnam Kim
- Sangmin ShinSSSangmin Shin
- Siwook ParkSPSiwook Park
- Junbeom KwonJKJunbeom Kwon
Preprint
- 4 August 2026
- preprint
- Published by Elsevier in SSRN Electronic Journal
Abstract
In this study, the perforation behaviors of commercial Armox 500T and Armox 600T were investigated under various projectile velocities. The failure mechanisms were analyzed from the macroscopic to the nanoscale using X-ray computed tomography (X-ray CT), electron backscatter diffraction (EBSD), and transmission electron microscopy (TEM). Under complete perforation conditions, Armox 600T exhibited greater initial resistance owing to its higher hardness but suffered severe rear-side damage (plugging and spalling). By contrast, Armox 500T exhibited extensive ductile hole expansion, maintaining a residual volume of approximately 99%. Microstructural characterization demonstrated that adiabatic shear bands (ASBs) were prominent near the perforation surfaces and along the radial cracks in both steels. The occurrence of dynamic recrystallization and even localized melting inside the ASBs induced microcracks along the ASB/matrix interfaces and prior austenite grain (PAG) boundaries, eventually coalescing into the observed macroscopic radial cracks. These findings suggest that the design of high-performance armor steels should be based on an optimized balance between hardness and dynamic damage tolerance.Keywords
This publication has 25 references indexed in Scilit:
- Evaluation of the test temperature effect on failure mechanisms and notched impact strength characteristics of ultra-hard low alloy steelsStrength of Materials, 2011
- Mapping the parent austenite orientation reconstructed from the orientation of martensite by EBSD and its application to ausformed martensiteActa Materialia, 2010
- Effect of Hardness on the Ballistic Impact Behavior of High-Strength Steels Against 7.62-mm Armor Piercing ProjectilesJournal of Materials Engineering and Performance, 2008
- Advances in X-ray Computed Tomography Diagnostics of Ballistic Impact DamageMetallurgical and Materials Transactions A, 2007
- The influence of plate hardness on the ballistic penetration of thick steel platesInternational Journal of Impact Engineering, 1995
- Dynamic recrystallization in high-strain, high-strain-rate plastic deformation of copperActa Metallurgica et Materialia, 1994
- The dependence of grain size on stress during dynamic recrystallisationActa Metallurgica et Materialia, 1991
- An experimental study of the formation process of adiabatic shear bands in a structural steelJournal of the Mechanics and Physics of Solids, 1988
- The interrelation of failure modes observed in the penetration of metallic targetsInternational Journal of Impact Engineering, 1984
- Hardness of tempered martensite in carbon and low-alloy steelsMetallurgical Transactions A, 1977