Sun-Woong Shin
Research Subjects
Sun-Woong Shin has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Bong Cheon Park
Materials Data & Analysis Research Division, Korea Institute of Materials Science, Changwon 51508, Republic of Korea
1 shared publication - Junbeom Kwon1 shared publication
Sangmin Shin
1 shared publication- Seung-Yong Lee
Materials Data & Analysis Research Division, Korea Institute of Materials Science, Changwon 51508, Republic of Korea
1 shared publication Siwook Park
1 shared publication- Yeongsu Ha
Department of Naval Architecture and Ocean Engineering, Pusan National University, Busan, Republic of Korea
1 shared publication
Latest Publications
- Open Access
- 4 August 2026
- Published by Elsevier in SSRN Electronic Journal
Multiscale failure mechanism of Armox 500T and 600T under complete ballistic perforation: Three-dimensional damage morphology and adiabatic shear band-assisted cracking
In this study, the perforation behaviors of commercial Armox 500T and Armox 600T were investigated under various projectile velocities. The failure mechanisms were analyzed from the macroscopic to the nanoscale using X-ray computed tomography (X-ray CT), electron backscatter diffraction (EBSD), and transmission electron microscopy (TEM). Under complete perforation conditions, Armox 600T exhibited greater initial resistance owing to its higher hardness but suffered severe rear-side damage (plugging and spalling). By contrast, Armox 500T exhibited extensive ductile hole expansion, maintaining a residual volume of approximately 99%. Microstructural characterization demonstrated that adiabatic shear bands (ASBs) were prominent near the perforation surfaces and along the radial cracks in both steels. The occurrence of dynamic recrystallization and even localized melting inside the ASBs induced microcracks along the ASB/matrix interfaces and prior austenite grain (PAG) boundaries, eventually coalescing into the observed macroscopic radial cracks. These findings suggest that the design of high-performance armor steels should be based on an optimized balance between hardness and dynamic damage tolerance.
- 4 August 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessMultiscale failure mechanism of Armox 500T and 600T under complete ballistic perforation: Three-dimensional damage morphology and adiabatic shear band-assisted cracking
In this study, the perforation behaviors of commercial Armox 500T and Armox 600T were investigated under various projectile velocities. The failure mechanisms were analyzed from the macroscopic to the nanoscale using X-ray computed tomography (X-ray CT), electron backscatter diffraction (EBSD), and transmission electron microscopy (TEM). Under complete perforation conditions, Armox 600T exhibited greater initial resistance owing to its higher hardness but suffered severe rear-side damage (plugging and spalling). By contrast, Armox 500T exhibited extensive ductile hole expansion, maintaining a residual volume of approximately 99%. Microstructural characterization demonstrated that adiabatic shear bands (ASBs) were prominent near the perforation surfaces and along the radial cracks in both steels. The occurrence of dynamic recrystallization and even localized melting inside the ASBs induced microcracks along the ASB/matrix interfaces and prior austenite grain (PAG) boundaries, eventually coalescing into the observed macroscopic radial cracks. These findings suggest that the design of high-performance armor steels should be based on an optimized balance between hardness and dynamic damage tolerance.