Dispersion of Zirconium Diboride in an Aqueous, High‐Solids Paste
- 24 September 2007
- journal article
- Published by Wiley in International Journal of Applied Ceramic Technology
- Vol. 4 (5) , 470-479
Abstract
The dispersion of ZrB2particles was investigated. In aqueous systems, the surface of ZrB2consists of a thin layer of ZrO2that controls the surface chemistry and surface charge. Measurements showed that the ZrB2had an isoelectric point of pH=4.7 and a maximum ζ potential of −50 mV at pH=9. The addition of a dispersant, either an ionic ammonium polyacrylate or a nonionic alkoxylated polyether, increased the ζ potential of ZrB2by as much as 60 mV to −110 mV. Viscosity measurements were used to optimize dispersant concentrations. High‐solids loading (∼45 vol.% ZrB2) aqueous pastes were prepared with two different dispersants. The pastes had viscosities of 40–50 Pa·s which was acceptable for extrusion, and were used to fabricate three‐dimensional components from ZrB2.Keywords
This publication has 24 references indexed in Scilit:
- Freeze-form extrusion fabrication of ceramic partsVirtual and Physical Prototyping, 2006
- Pressureless Densification of Zirconium Diboride with Boron Carbide AdditionsJournal of the American Ceramic Society, 2006
- Properties of a Pressureless‐Sintered ZrB2–MoSi2 Ceramic CompositeJournal of the American Ceramic Society, 2006
- High Thermal Conductivity Aluminum Nitride Substrates Prepared by Aqueous Tape CastingJournal of the American Ceramic Society, 2006
- Improvement of the Dispersion of Al2O3 Slurries Using EDTA‐4NaJournal of the American Ceramic Society, 2006
- Dispersing Properties of Copolymers Able to Act as BindersJournal of the American Ceramic Society, 2005
- Role of Bound Water on the Viscosity of Nanometric Alumina SuspensionsJournal of the American Ceramic Society, 2005
- Aqueous Processing of Titanium Carbide Green SheetsJournal of the American Ceramic Society, 2001
- Powder Processing Science and Technology for Increased ReliabilityJournal of the American Ceramic Society, 1989
- Stability of Aqueous α‐Al 2 O 3 Suspensions with Poly(methacrylic acid) PolyelectrolyteJournal of the American Ceramic Society, 1988