Achieving High Capacity in Nickel‐Rich Cathodes via Low‐Voltage Lithium Storage Expansion
Abstract
Lithium‐excess configurations accessed at low cutoff voltages in nickel‐rich layered oxides offer a promising route to increasing cathode capacity but are typically accompanied by rapid performance degradation and poor cycling stability. To address this challenge, we propose a constant‐capacity (CCap) protocol that fixes the discharge capacity at a prescribed value. By selectively accessing the low‐voltage lithium‐storage reservoir while limiting the extent of lithiation below the stoichiometric threshold, this strategy suppresses uncontrolled deep lithiation and mitigates structural degradation. Li||NCM811 half‐cells achieve extended cycling stability, delivering up to 300, 500, and 600 cycles at 100%, 90%, and 80% capacity retention, respectively. X‐ray diffraction analysis reveals that capacity extension during cycling originates from the low‐voltage regime through the formation of a Li 2 ‐NCM811 phase, which enables high‐capacity output. Although the average discharge voltage decreases, the average energy density under specific discharge cycles is approximately 10% higher than that achieved with conventional voltage‐controlled cycling at the same cycle number. Notably, Li||NCM811 full cells operated at a negative‐to‐positive capacity ratio of 4 retain full capacity over 200 cycles while maintaining a higher energy density than that obtained under standard cycling conditions for up to 180 cycles.Keywords
Funding Information
- University of Chinese Academy of Sciences (WIUCASSWWL22001)
- University of Chinese Academy of Sciences (WIUCASQD2020004)
- University of Chinese Academy of Sciences (WIUCASQD2023003)
This publication has 27 references indexed in Scilit:
- Rational design and scalable engineering of artificial interphases for lithium metal anodesJournal of Energy Chemistry, 2025
- Recent advances and challenges of eco-friendly Ni-rich cathode slurry systems in lithium-ion batteriesActa Physico-Chimica Sinica, 2025
- Unveiling the Over‐Lithiation Behavior of NCM523 Cathode Towards Long‐Life Anode‐Free Li Metal BatteriesAdvanced Science, 2025
- Dense All‐Electrochem‐Active Electrodes for All‐Solid‐State Lithium BatteriesAdvanced Materials, 2021
- Li‐Rich Li2[Ni0.8Co0.1Mn0.1]O2 for Anode‐Free Lithium Metal BatteriesAngewandte Chemie International Edition, 2021
- Microstructural visualization of compositional changes induced by transition metal dissolution in Ni-rich layered cathode materials by high-resolution particle analysisNano Energy, 2019
- A perspective on nickel-rich layered oxide cathodes for lithium-ion batteriesEnergy Storage Materials, 2017
- In-situ X-ray diffraction study on the structural reversibility of lithium nickel cobalt oxide in a broad electrochemical window of 1.35–4.3 VElectrochimica Acta, 2016
- Electrochemical stability of aluminum current collector in alkyl carbonate electrolytes containing lithium bis(pentafluoroethylsulfonyl)imide for lithium-ion batteriesJournal of Power Sources, 2014
- Comparison of the structural and electrochemical properties of layered Li[NixCoyMnz]O2 (x = 1/3, 0.5, 0.6, 0.7, 0.8 and 0.85) cathode material for lithium-ion batteriesJournal of Power Sources, 2013