Effects of Purge Jet Momentum on Sealing Effectiveness
- 4 October 2016
- journal article
- Published by ASME International in Journal of Engineering for Gas Turbines and Power
- Vol. 139 (3) , 031904
Abstract
Driven by the need for higher cycle efficiencies, overall pressure ratios for gas turbine engines continue to be pushed higher thereby resulting in increasing gas temperatures. Secondary air, bled from the compressor, is used to cool turbine components and seal the cavities between stages from the hot main gas path. This paper compares a range of purge flows and two different purge hole configurations for introducing the purge flow into the rim cavities. In addition, the mate face gap leakage between vanes is investigated. For this particular study, stationary vanes at engine-relevant Mach and Reynolds numbers were used with a static rim seal and rim cavity to remove rotational effects and isolate gas path effects. Sealing effectiveness measurements, deduced from the use of CO2 as a flow tracer, indicate that the effectiveness levels on the stator and rotor side of the cavity depend on the mass and momentum flux ratios of the purge jets relative to the swirl velocity. For a given purge flow rate, fewer purge holes resulted in better sealing than the case with a larger number of holes.Keywords
This publication has 17 references indexed in Scilit:
- Design of an Improved Turbine Rim-SealJournal of Engineering for Gas Turbines and Power, 2015
- Experimental Measurements of Ingestion Through Turbine Rim Seals—Part III: Single and Double SealsJournal of Turbomachinery, 2013
- Computational extrapolation of turbine sealing effectiveness from test rig to engine conditionsProceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, 2012
- Experimental Measurements of Ingestion Through Turbine Rim Seals—Part I: Externally Induced IngressJournal of Turbomachinery, 2012
- Experimental Measurements of Ingestion Through Turbine Rim Seals—Part II: Rotationally Induced IngressJournal of Turbomachinery, 2012
- Main Gas Ingestion in a Turbine Stage for Three Rim Cavity ConfigurationsJournal of Turbomachinery, 2010
- Prediction of Ingestion Through Turbine Rim Seals—Part II: Externally Induced and Combined IngressJournal of Turbomachinery, 2010
- An Investigation of Turbine Wheelspace Cooling Flow Interactions With a Transonic Hot Gas Path—Part 1: Experimental MeasurementsJournal of Turbomachinery, 2010
- Turbine Stator Well CFD Studies: Effects of Coolant Supply Geometry on Cavity Sealing PerformanceJournal of Turbomachinery, 2010
- Aerodynamic aspects of the sealing of gas-turbine rotor-stator systemsInternational Journal of Heat and Fluid Flow, 1988