Paul Hiester
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Paul Hiester has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Carey Clum
Pratt & Whitney, East Hartford, CT 06118
1 shared publication - Christopher Robak
Pratt & Whitney, East Hartford, CT 06118
1 shared publication - Curtis Memory
Pratt & Whitney, East Hartford, CT 06118
1 shared publication - Karen A. Thole
Pennsylvania State University Department of Mechanical Engineering 3127 Research Drive, State College, PA 16801
1 shared publication - Kenneth Clark
Department of Mechanical and Nuclear Engineering, The Pennsylvania State University, University Park, PA 16802
1 shared publication - Michael D. Barringer
The Pennsylvania State University Department of Mechanical Engineering University Park, PA 16802
1 shared publication
Latest Publications
- 4 October 2016
- Published by ASME International in Journal of Engineering for Gas Turbines and Power
- Vol. 139 (3) , 031904
Effects of Purge Jet Momentum on Sealing Effectiveness
Driven by the need for higher cycle efficiencies, overall pressure ratios for gas turbine engines continue to be pushed higher thereby resulting in increasing gas temperatures. Secondary air, bled from the compressor, is used to cool turbine components and seal the cavities between stages from the hot main gas path. This paper compares a range of purge flows and two different purge hole configurations for introducing the purge flow into the rim cavities. In addition, the mate face gap leakage between vanes is investigated. For this particular study, stationary vanes at engine-relevant Mach and Reynolds numbers were used with a static rim seal and rim cavity to remove rotational effects and isolate gas path effects. Sealing effectiveness measurements, deduced from the use of CO2 as a flow tracer, indicate that the effectiveness levels on the stator and rotor side of the cavity depend on the mass and momentum flux ratios of the purge jets relative to the swirl velocity. For a given purge flow rate, fewer purge holes resulted in better sealing than the case with a larger number of holes.
- 4 October 2016
- Published by ASME International in Journal of Engineering for Gas Turbines and Power
- Vol. 139 (3) , 031904
Effects of Purge Jet Momentum on Sealing Effectiveness
Driven by the need for higher cycle efficiencies, overall pressure ratios for gas turbine engines continue to be pushed higher thereby resulting in increasing gas temperatures. Secondary air, bled from the compressor, is used to cool turbine components and seal the cavities between stages from the hot main gas path. This paper compares a range of purge flows and two different purge hole configurations for introducing the purge flow into the rim cavities. In addition, the mate face gap leakage between vanes is investigated. For this particular study, stationary vanes at engine-relevant Mach and Reynolds numbers were used with a static rim seal and rim cavity to remove rotational effects and isolate gas path effects. Sealing effectiveness measurements, deduced from the use of CO2 as a flow tracer, indicate that the effectiveness levels on the stator and rotor side of the cavity depend on the mass and momentum flux ratios of the purge jets relative to the swirl velocity. For a given purge flow rate, fewer purge holes resulted in better sealing than the case with a larger number of holes.