Tribological Performances of Polymer-Based Coating Materials Designed for Compressor Applications
Authors:
- 27 October 2010
- conference paper
- Published by Trans Tech Publications, Ltd. in Advances in Science and Technology
- Vol. 64, 33-42
Abstract
With increasing importance of advanced coating materials for use in interacting parts of air-conditioning compressors, several commercially available polymer-based coatings (PTFE/ Pyrrolidone-1, 2, PTFE/MoS2-1, 2, Fluorocarbon, PEEK/PTFE and PEEK/Ceramic coatings) were tribologically evaluated. Friction and wear behavior of these coatings, deposited on gray cast iron were in-situ measured using a specialized pin-on-disk tribometer. The experiments were performed under compressor specific conditions, namely under oscillatory motion simulating piston-type compressor and unidirectional motion simulating swash plate-type compressor operation. Also, the tribological properties of newly developed ATSP-based coatings deposited on aluminum substrates were evaluated under ball-on-disk, unidirectional sliding experiments. Polymer-based coatings exhibited excellent frictional properties, while their wear resistance was also acceptable, even though lower compared to hard coatings. However, the wear debris generated at the interface acted as a third-body solid lubricant with a beneficial role in their overall performance. ATSP coatings blended with fluoroadditives showed superior frictional behavior than pure ATSP coatings, and their wear rate was extremely low compared to commercially available PTFE-based coatings.Keywords
This publication has 23 references indexed in Scilit:
- Tribological performance of PTFE-based coatings for air-conditioning compressorsSurface and Coatings Technology, 2008
- A new family of low wear, low coefficient of friction polymer blend based on polytetrafluoroethylene and an aromatic thermosetting polyesterPolymers for Advanced Technologies, 2008
- Friction and wear behavior of poly(vinyl alcohol)/poly(vinyl pyrrolidone) hydrogels for articular cartilage replacementJournal of Biomedical Materials Research Part A, 2007
- Analytical determination of the surface energy of sub-5nm head-disk interfaces accounting for multilayer effectsJournal of Applied Physics, 2006
- Nanomechanical Properties of Aluminum 390-T6 Rough Surfaces Undergoing Tribological TestingJournal of Tribology, 2004
- Sliding wear behaviour of PEEK‐PTFE blendsJournal of Synthetic Lubrication, 2003
- A study on the friction and wear behavior of PTFE filled with alumina nanoparticlesWear, 2003
- Diamond-like amorphous carbonMaterials Science and Engineering: R: Reports, 2002
- Low-friction hydrophilic surface for medical devicesBiomaterials, 1990
- A review of scuffing and running-in of lubricated surfaces, with asperities and oxides in perspectiveWear, 1984